Skip to contentSkip to conversation

SATA Performance with Intel ICH6

DISCUSSION Martin A. Fink 2 participants 2 messages Nov 28, 2006

lore
Share & tools
lore
#0 lore raw

Dear Alan,

You wrote

Quoted 5 lines

The PIIX interface needs CPU intervention each command, so in practice about every 64K or so, and the CPU gets stalled waiting for the disk during the setup of each I/O. The newer kernels support AHCI which does not have this overhead, but it is only present on the newest intel controllers.

Can you tell me the name of these newest controllers? Is it ICH7 or 8 ? What kernel versions? dmesg only shows ACPI and u/e/o hci_* host controller. (kernel version is 2.6.8-24.25-smp). How can I switch to AHCI ?

Thank you very much,

Martin

#1 lore raw
Quoted 9 lines · On Tue, 28 Nov 2006 11:09:47 +0100 "Martin A. Fink" <[email protected]> wrote:

Dear Alan,

You wrote

Quoted 5 lines

The PIIX interface needs CPU intervention each command, so in practice about every 64K or so, and the CPU gets stalled waiting for the disk during the setup of each I/O. The newer kernels support AHCI which does not have this overhead, but it is only present on the newest intel controllers.

Quoted 3 lines

Can you tell me the name of these newest controllers? Is it ICH7 or 8 ? What kernel versions? dmesg only shows ACPI and u/e/o hci_* host controller. (kernel version is 2.6.8-24.25-smp). How can I switch to AHCI ?

According to the docs

ICH6
ICH6M
ICH7
ICH7M
ICH7R
ESB2
ICH7-M DH
ICH8
ICH8M

These devices support both "legacy" and "ahci" modes of operation, usually controlled by a BIOS setting.