softmac: remove netif_tx_disable when scanning
Subsystems (2)
PATCH 1/1 softmac: remove netif_tx_disable when scanning
From: Michael Buesch <[email protected]>
In the scan section of ieee80211softmac, network transmits are disabled. When SoftMAC re-enables transmits, it may override the wishes of a driver that may have very good reasons for disabling transmits. At least one failure in bcm43xx can be traced to this problem. In addition, several unexplained problems may arise from the unexpected enabling of transmits. Note that making this change introduces a new bug that would allow transmits for the current session to be transmitted on the wrong channel; however, the new bug is much less severe than the one being fixed, as the new one only leads to a few retransmits, whereas the old one can bring the interface down.
A fix that will not introduce new bugs is being investigated; however, the current, more serious one should be fixed now.
---
John,
I assume you have seen the discussion on this matter in the netdev mailing list. I agree with Michael that this patch should be applied despite the intoduction of a new bug. Please apply this to wireless-2.6 and push it upstream for inclusion in 2.6.19, if possible. I will be submitting it to 2.6.18.Y.
Larry
net/ieee80211/softmac/ieee80211softmac_scan.c +0 -2
@@ -47,7 +47,6 @@ ieee80211softmac_start_scan(struct ieee8 sm->scanning =1 ;spin_unlock_irqrestore (&sm->lock, flags); -netif_tx_disable (sm->ieee->dev); ret = sm->start_scan (sm->dev);if (ret) {spin_lock_irqsave (&sm->lock, flags);
@@ -248,7 +246,6 @@ void ieee80211softmac_scan_finished(struif (net) sm->set_channel (sm->dev, net->channel); } -netif_wake_queue (sm->ieee->dev);ieee80211softmac_call_events (sm,IEEE80211SOFTMAC_EVENT_SCAN_FINISHED ,NULL ); }EXPORT_SYMBOL_GPL (ieee80211softmac_scan_finished);
---
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 9 lines · Larry Finger
From: Michael Buesch <[email protected]>
In the scan section of ieee80211softmac, network transmits are disabled. When SoftMAC re-enables transmits, it may override the wishes of a driver that may have very good reasons for disabling transmits. At least one failure in bcm43xx can be traced to this problem. In addition, several unexplained problems may arise from the unexpected enabling of transmits.
Quoted 3 lines
Note that
making this change introduces a new bug that would allow transmits for the current session to be transmitted on the wrong channel;
Nono, please don't confuse that.
It does not _indruduce_ a new bug. The bug is already there. It's only less likely to trigger without this bugfix patch.
Quoted 3 lines
however, the new bug
is much less severe than the one being fixed, as the new one only leads to a few retransmits, whereas the old one can bring the interface down.
Yeah, that too.
Signature · 1 line
Greetings Michael.