2.6.19: ALi M5229 - CD-ROM not found with pata_ali
A message that is not in the archive (sent off-list or not yet received): [email protected]
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Quoted 11 lines · Andrey Borzenkov
Just in case you have missed this on LKML :)
Quoted 4 lines · Alan Cox
http://zeniv.linux.org.uk/~alan/IDE
This is basically a resync versus 2.6.17, the head of the PATA tree is now built against Jeffs tree with revised error handling and the like.
Running vanilla 2.6.17 + ide1 patch on ALi M5229 does not find CD-ROM. Notice "ata2: command
0xa0timeout" below.
Still the same in 2.6.19 + suspend pata_ali patch. The only way I can get CD-ROM is with
options pata_ali atapi_max_xfer_mask=0x7f
and patch
drivers/ata/pata_ali.c +0 -0
- --- a/drivers/ata/pata_ali.c
+++ b/drivers/ata/pata_ali.c
@@ -329,6 +329,16 @@ static void ali_lock_sectors(struct ata_
adev->max_sectors = 255;
}
+static unsigned long atapi_max_xfer_mask = ~0; +module_param(atapi_max_xfer_mask, ulong, 644);
+
+static unsigned long ali_mode_filter(const struct ata_port *ap, struct ata_devi
ce *adev, unsigned long xfer_mask)
+{
+ if (adev->class == ATA_DEV_ATAPI)
+ xfer_mask &= atapi_max_xfer_mask;
+ return ata_pci_default_filter(ap, adev, xfer_mask);
+}
+
static struct scsi_host_template ali_sht = {
.module = THIS_MODULE,
.name = DRV_NAME,
@@ -428,7 +438,7 @@ static struct ata_port_operations ali_c2
.port_disable = ata_port_disable,
.set_piomode = ali_set_piomode,
.set_dmamode = ali_set_dmamode,
- - .mode_filter = ata_pci_default_filter,
+ .mode_filter = ali_mode_filter,
.tf_load = ata_tf_load,
.tf_read = ata_tf_read,
.check_status = ata_check_status,allowing even MWDMA results in the same timeouts and CD-ROM not found.
Quoted 90 lines
ata1: PATA max UDMA/100 cmd
0x1F0ctl0x3F6bmdma0xEFF0irq 14
ata1: dev 0 cfg 49:0f00 82:746b 83:49a8 84:4003 85:f469 86:0808 87:4003 88:103f
ata1: dev 0 ATA-5, max UDMA/100, 39070080 sectors: LBA
ata1: dev 0 configured for UDMA/33
scsi0 : ali
Vendor: ATA Model: IC25N020ATDA04-0 Rev: DA3O
Type: Direct-Access ANSI SCSI revision: 05
ata2: PATA max UDMA/100 cmd0x170ctl0x376bmdma0xEFF8irq 15
ata2: dev 0 cfg 49:0f00 82:0000 83:0000 84:0000 85:0000 86:0000 87:0000 88:0407
ata2: dev 0 ATAPI, max UDMA/33
ata2: dev 0 configured for UDMA/33
scsi1 : ali
ata2: command0xa0timeout, stat0x58host_stat0x21
ata2: translated ATA stat/err 0x58/00 to SCSI SK/ASC/ASCQ 0xb/47/00 SCSI device sda: 39070080 512-byte hdwr sectors (20004 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 39070080 512-byte hdwr sectors (20004 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
sda: sda1 sda2
sd 0:0:0:0: Attached scsi disk sdaOtherwise I am pretty much impressed.
00:00.0 Host bridge: ALi Corporation M1644/M1644T Northbridge+Trident (rev
01)
00:01.0 PCI bridge: ALi Corporation PCI to AGP Controller 00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) 00:04.0 IDE interface: ALi Corporation M5229 IDE (rev c3) 00:06.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link Controller Audio Device (rev 01)
00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] 00:08.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU] 00:0a.0 Ethernet controller: Intel Corporation 82557/8/9 [Ethernet Pro 100] (rev 08)
00:10.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus Controller (rev 01)
00:11.0 CardBus bridge: Toshiba America Info Systems ToPIC100 PCI to Cardbus Bridge with ZV Support (rev 32)
00:11.1 CardBus bridge: Toshiba America Info Systems ToPIC100 PCI to Cardbus Bridge with ZV Support (rev 32)
00:12.0 System peripheral: Toshiba America Info Systems SD TypA Controller (rev 03)
01:00.0 VGA compatible controller: Trident Microsystems CyberBlade XPAi1 (rev 82)And running "classical" IDE:
{pts/0}% sudo cat
/proc/ide/hdc/model
TOSHIBA DVD-ROM SD-C2502
{pts/0}% sudo cat/proc/ide/hdc/identify
85c0 0000 0000 0000 0000 0000 0000 0000
0000 0000 3031 3030 3230 3839 3338 2020
2020 2020 2020 2020 0000 0100 0000 3133
3133 2020 2020 544f 5348 4942 4120 4456
442d 524f 4d20 5344 2d43 3235 3032 2020
2020 2020 2020 2020 2020 2020 2020 0000
0000 0f00 0000 0400 0200 0006 0000 0000
0000 0000 0000 0000 0000 0000 0007 0007
0003 0078 0078 0078 0078 0000 0000 0000
0000 0004 0009 0000 0000 0000 0000 0000
003c 0013 0000 0000 0000 0000 0000 0000
0407 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
Quoted 1 line
-andrey
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (GNU/Linux)
iD8DBQFFcJIRR6LMutpd94wRAsqXAJ4w1VBxw02K3T34jKMZwUg9MYGC9ACgxdvC j1aeeIhuPpqSj2cnOrCiArQ=
=RXGM
-----END PGP SIGNATURE-----
Quoted 28 lines · On Fri, 1 Dec 2006 23:35:28 +0300 Andrey Borzenkov wrote:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1Quoted 11 lines · Andrey Borzenkov
Just in case you have missed this on LKML :)
Quoted 4 lines · Alan Cox
http://zeniv.linux.org.uk/~alan/IDE
This is basically a resync versus 2.6.17, the head of the PATA tree is now built against Jeffs tree with revised error handling and the like.
Running vanilla 2.6.17 + ide1 patch on ALi M5229 does not find CD-ROM. Notice "ata2: command
0xa0timeout" below.Still the same in 2.6.19 + suspend
pata_alipatch. The only way I can get CD-ROM is withoptions
pata_aliatapi_max_xfer_mask=0x7fand patch
drivers/ata/pata_ali.c +1
-1- --- a/drivers/ata/pata_ali.c +++ b/drivers/ata/pata_ali.c
drivers/ata/pata_ali.c static void ali_lock_sectors(struct ata_ · line 333
Quoted 5 lines
drivers/ata/pata_ali.c +2
-0@@ -329,6 +329,16 @@ static void ali_lock_sectors(struct ata_ adev->max_sectors =255 ; } +static unsigned long atapi_max_xfer_mask = ~0 ; +module_param (atapi_max_xfer_mask, ulong,644 );
^^^
BTW: 0644
Quoted 23 lines
drivers/ata/pata_ali.c +2
-0+ +static unsigned long ali_mode_filter(const struct ata_port *ap, struct
ata_devi
ce *adev, unsigned longxfer_mask)drivers/ata/pata_ali.c +7
-1+{ +if (adev->class ==ATA_DEV_ATAPI ) + xfer_mask &= atapi_max_xfer_mask; +return ata_pci_default_filter (ap, adev, xfer_mask); +} +static struct scsi_host_template ali_sht = { .module =THIS_MODULE , .name =DRV_NAME ,@@ -428,7 +438,7 @@ static struct ata_port_operations ali_c2 .port_disable = ata_port_disable, .set_piomode = ali_set_piomode, .set_dmamode = ali_set_dmamode, - - .mode_filter = ata_pci_default_filter, + .mode_filter = ali_mode_filter, .tf_load = ata_tf_load, .tf_read = ata_tf_read, .check_status = ata_check_status,
Quoted 1 line
allowing even MWDMA results in the same timeouts and CD-ROM not found.
---
~Randy
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Quoted 6 lines · Randy Dunlap
Review
Quoted 2 lines
(quoted diff) +2
-0+static unsigned long atapi_max_xfer_mask = ~0; +module_param(atapi_max_xfer_mask, ulong, 644);^^^BTW: 0644
Tnx :)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (GNU/Linux)
iD8DBQFFcJlRR6LMutpd94wRAoa2AJwMIINzZMYEef5z1uiZoszImXA0nwCgkhdB SmFMtClM1+xEcmI6WZ8PkvY=
=co6P
-----END PGP SIGNATURE-----
Quoted 4 lines
Still the same in 2.6.19 + suspend
pata_alipatch. The only way I can get CD-ROM is withoptions
pata_aliatapi_max_xfer_mask=0x7f
And I've still got no idea why. Having studied the docs, the old and new drivers and a lot more I see no difference to explain it.
Alan
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Quoted 8 lines · Alan
Quoted 4 lines
Still the same in 2.6.19 + suspend
pata_alipatch. The only way I can get CD-ROM is withoptions
pata_aliatapi_max_xfer_mask=0x7fAnd I've still got no idea why. Having studied the docs, the old and new drivers and a lot more I see no difference to explain it.
Irrespectively - why libata does not fall back to PIO when DMA failed? This at least would have given working device (even somewhat degraded perfrormance).
- -andrey
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (GNU/Linux)
iD4DBQFFce+7R6LMutpd94wRAqC6AKDR6zjJ+WDTT6S/7DEOtqGlZ3UgUQCY5tgY 6w8LI78xoTsFDc6sO5vs0A==
=tMFh
-----END PGP SIGNATURE-----