Skip to contentSkip to conversation

SMP boot hook for paravirt

PATCH New Zachary Amsden 1 participant 1 message Dec 15, 2006

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 4/6 SMP boot hook for paravirt

Add VMI SMP boot hook. We emulate a regular boot sequence and use the same APIC IPI initiation, we just poke magic values to load into the CPU state when the startup IPI is received, rather than having to jump through a real mode trampoline.

This is all that was needed to get SMP to work.

Subject: SMP boot hook for paravirt

arch/i386/kernel/paravirt.c +2 -0
diff -r acfb7a15715f arch/i386/kernel/paravirt.c
@@ -572,5 +572,7 @@ struct paravirt_ops paravirt_ops = {
 
 	.irq_enable_sysexit = native_irq_enable_sysexit,
 	.iret = native_iret,
+
+	.startup_ipi_hook = (void *)native_nop,
 };
 EXPORT_SYMBOL(paravirt_ops);
arch/i386/kernel/smpboot.c +7 -0
diff -r acfb7a15715f arch/i386/kernel/smpboot.c
@@ -831,6 +831,13 @@ wakeup_secondary_cpu(int phys_apicid, un
 		num_starts = 0;
 
 	/*
+	 * Paravirt / VMI wants a startup IPI hook here to set up the
+	 * target processor state.
+	 */
+	startup_ipi_hook(phys_apicid, (unsigned long) start_secondary,
+		         (unsigned long) stack_start.esp);
+
+	/*
 	 * Run STARTUP IPI loop.
 	 */
 	Dprintk("#startup loops: %d.\n", num_starts);
include/asm-i386/paravirt.h +9 -0
diff -r acfb7a15715f include/asm-i386/paravirt.h
@@ -151,6 +151,8 @@ struct paravirt_ops
 	/* These two are jmp to, not actually called. */
 	void (fastcall *irq_enable_sysexit)(void);
 	void (fastcall *iret)(void);
+
+	void (fastcall *startup_ipi_hook)(int phys_apicid, unsigned long start_eip, unsigned long start_esp);
 };
 
 /* Mark a paravirt probe function. */
@@ -323,6 +325,13 @@ static inline unsigned long apic_read(un
 }
 #endif
 
+#ifdef CONFIG_SMP
+static inline void startup_ipi_hook(int phys_apicid, unsigned long start_eip,
+				    unsigned long start_esp)
+{
+	return paravirt_ops.startup_ipi_hook(phys_apicid, start_eip, start_esp);
+}
+#endif
 
 #define __flush_tlb() paravirt_ops.flush_tlb_user()
 #define __flush_tlb_global() paravirt_ops.flush_tlb_kernel()
include/asm-i386/smp.h +5 -0
diff -r acfb7a15715f include/asm-i386/smp.h
@@ -52,6 +52,11 @@ extern void cpu_uninit(void);
 extern void cpu_uninit(void);
 #endif
 
+#ifndef CONFIG_PARAVIRT
+#define startup_ipi_hook(phys_apicid, start_eip, start_esp) 		\
+do { } while (0)
+#endif
+
 /*
  * This function is needed by all SMP systems. It must _always_ be valid
  * from the initial startup. We map APIC_BASE very early in page_setup(),