Skip to contentSkip to conversation

Avoid assigning PCI resources from zero address

PATCH New Sergei Shtylyov 1 participant 1 message Dec 27, 2006

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Avoid assigning PCI resources from zero address

If a PCI IDE card happens to get a zero address assigned to it, the Linux IDE core complains and IDE drivers fails to work. Also, assigning zero to a BAR was illegal according to PCI 2.1 (the later revisions seem to have excluded the sentence about "0" being considered an invalid address) -- so, use a reasonable starting value of 0x1000 (that's what the most Linux archs are using).

Alternatively, one might have fixed the calls to pci_set_region() individually (some code even seems to have taken care of this issue) but that would have been a lot more work. :-)

 drivers/pci_auto.c |    7 ++++++-
 1 files changed, 6 insertions(+), 1 deletion(-)
drivers/pci_auto.c +6 -1
Index: u-boot/drivers/pci_auto.c
===================================================================
@@ -34,7 +34,12 @@
 
 void pciauto_region_init(struct pci_region* res)
 {
-	res->bus_lower = res->bus_start;
+	/*
+	 * Avoid allocating PCI resources from address 0 -- this is illegal
+	 * according to PCI 2.1 and moreover, this is known to cause Linux IDE
+	 * drivers to fail. Use a reasonable starting value of 0x1000 instead.
+	 */
+	res->bus_lower = res->bus_start ? res->bus_start : 0x1000;
 }
 
 void pciauto_region_align(struct pci_region *res, unsigned long size)