Longhaul - Fix hole
PATCH 1/1 Longhaul - Fix hole
User with Nehemiah B is complain that Longhaul don't work for him. I don't know much about this issue in this moment, but looking at source I see possible bug related to ACPI PM2 register. Patch below.
Merry Christmas
Weso³ych ¦wi±t
---
arch/i386/kernel/cpu/cpufreq/longhaul.c +0 -0
@@ -52,6 +52,10 @@
#define CPU_EZRA_T 4
#define CPU_NEHEMIAH 5
+/* Flags */
+#define USE_ACPI_C3 (1 << 1)
+#define USE_NORTHBRIDGE (1 << 2)
+
static int cpu_model;
static unsigned int numscales=16;
static unsigned int fsb;
@@ -68,7 +72,7 @@ static unsigned int minmult, maxmult; static int can_scale_voltage;
static struct acpi_processor *pr = NULL; static struct acpi_processor_cx *cx = NULL; -static int port22_en;
+static u8 longhaul_flags;
/* Module parameters */
static int scale_voltage;
@@ -80,7 +84,6 @@ static int ignore_latency;
/* Clock ratios multiplied by 10 */
static int clock_ratio[32];
static int eblcr_table[32];
-static unsigned int highest_speed, lowest_speed; /* kHz */ static int longhaul_version;
static struct cpufreq_frequency_table *longhaul_table;
@@ -178,7 +181,7 @@ static void do_powersaver(int cx_address, unsigned int clock_ratio_index)
safe_halt();
/* Change frequency on next halt or sleep */
wrmsrl(MSR_VIA_LONGHAUL, longhaul.val);
- if (port22_en) {
+ if (!cx_address) {
ACPI_FLUSH_CPU_CACHE();
/* Invoke C1 */
halt();
@@ -189,7 +192,6 @@ static void do_powersaver(int cx_address, unsigned int clock_ratio_index)
/* Dummy op - must do something useless after P_LVL3 read */
t = inl(acpi_fadt.xpm_tmr_blk.address);
}
-
/* Disable bus ratio bit */
local_irq_disable();
longhaul.bits.RevisionKey = longhaul.bits.RevisionID;
@@ -243,15 +245,14 @@ static void longhaul_setstate(unsigned int clock_ratio_index)
outb(0xFF,0xA1); /* Overkill */
outb(0xFE,0x21); /* TMR0 only */- if (pr->flags.bm_control) {
+ if (longhaul_flags & USE_NORTHBRIDGE) {
+ /* Disable AGP and PCI arbiters */
+ outb(3, 0x22);
+ } else if ((pr != NULL) && pr->flags.bm_control) {
/* Disable bus master arbitration */
acpi_set_register(ACPI_BITREG_ARB_DISABLE, 1,
ACPI_MTX_DO_NOT_LOCK);
- } else if (port22_en) {
- /* Disable AGP and PCI arbiters */
- outb(3, 0x22);
}
-
switch (longhaul_version) {
/*
@@ -278,22 +279,25 @@ static void longhaul_setstate(unsigned int clock_ratio_index)
* to work in practice.
*/
case TYPE_POWERSAVER:- /* Don't allow wakeup */
- acpi_set_register(ACPI_BITREG_BUS_MASTER_RLD, 0,
- ACPI_MTX_DO_NOT_LOCK);
- do_powersaver(cx->address, clock_ratio_index);
+ if (longhaul_flags & USE_ACPI_C3) {
+ /* Don't allow wakeup */
+ acpi_set_register(ACPI_BITREG_BUS_MASTER_RLD, 0,
+ ACPI_MTX_DO_NOT_LOCK);
+ do_powersaver(cx->address, clock_ratio_index);
+ } else {
+ do_powersaver(0, clock_ratio_index);
+ }
break; }
- if (pr->flags.bm_control) {
+ if (longhaul_flags & USE_NORTHBRIDGE) {
+ /* Enable arbiters */
+ outb(0, 0x22);
+ } else if ((pr != NULL) && pr->flags.bm_control) {
/* Enable bus master arbitration */
acpi_set_register(ACPI_BITREG_ARB_DISABLE, 0,
ACPI_MTX_DO_NOT_LOCK);
- } else if (port22_en) {
- /* Enable arbiters */
- outb(0, 0x22);
}
-
outb(pic2_mask,0xA1); /* restore mask */
outb(pic1_mask,0x21);@@ -691,27 +695,32 @@ static int __init longhaul_cpu_init(struct cpufreq_policy *policy)
/* Find ACPI data for processor */ acpi_walk_namespace(ACPI_TYPE_PROCESSOR, ACPI_ROOT_OBJECT, ACPI_UINT32_MAX, &longhaul_walk_callback, NULL, (void *)&pr);
- if (pr == NULL)
- goto err_acpi;
- if (longhaul_version == TYPE_POWERSAVER) {
- /* Check ACPI support for C3 state */
+ /* Check ACPI support for C3 state */
+ if ((pr != NULL) && (longhaul_version == TYPE_POWERSAVER)) {
cx = &pr->power.states[ACPI_STATE_C3];
if (cx->address > 0 &&
(cx->latency <= 1000 || ignore_latency != 0) ) {
+ longhaul_flags |= USE_ACPI_C3;
goto print_support_type;
}
}+ /* Check if northbridge is friendly */
+ if (enable_arbiter_disable()) {
+ longhaul_flags |= USE_NORTHBRIDGE;
+ goto print_support_type;
+ }
+
+ /* No ACPI C3 or we can't use it */
/* Check ACPI support for bus master arbiter disable */
- if (!pr->flags.bm_control) {
- if (enable_arbiter_disable()) {
- port22_en = 1;
- } else {
- goto err_acpi;
- }
+ if ((pr == NULL) || !(pr->flags.bm_control)) {
+ printk(KERN_ERR PFX + "No ACPI support. Unsupported northbridge.\n");
+ return -ENODEV;
}
+
print_support_type:
- if (!port22_en) {
+ if (!(longhaul_flags & USE_NORTHBRIDGE)) {
printk (KERN_INFO PFX "Using ACPI support.\n");
} else {
printk (KERN_INFO PFX "Using northbridge support.\n");
@@ -736,10 +745,6 @@ print_support_type:
cpufreq_frequency_table_get_attr(longhaul_table, policy->cpu);
return 0;-
-err_acpi:
- printk(KERN_ERR PFX "No ACPI support. Unsupported northbridge. Aborting.\n");
- return -ENODEV;
}
static int __devexit longhaul_cpu_exit(struct cpufreq_policy *policy) @@ -774,8 +779,8 @@ static int __init longhaul_init(void)
#ifdef CONFIG_SMP
if (num_online_cpus() > 1) {
- return -ENODEV;
printk(KERN_ERR PFX "More than 1 CPU detected, longhaul disabled.\n");
+ return -ENODEV;
}#endif
#ifdef CONFIG_X86_IO_APIC
----------------------------------------------------------------------
Jestes kierowca? To poczytaj! >>> http://link.interia.pl/f199e
Quoted 4 lines · RafaÅ‚ Bilski
User with Nehemiah B is complain that Longhaul don't work for him. I don't know much about this issue in this moment, but looking at source I see possible bug related to ACPI PM2 register. Patch below.
Can you go into some more detail for the purpose of the changelog? The above is very vague.
Review static int __init longhaul_init(void) · line 785
Quoted 10 lines
static int
__devexitlonghaul_cpu_exit(struct cpufreq_policy *policy)(quoted diff) +1
-1@@ -774,8 +779,8 @@ static int __init longhaul_init(void) #ifdef CONFIG_SMP if (num_online_cpus() > 1) { - return -ENODEV; printk(KERN_ERR PFX "More than 1 CPU detected, longhaul disabled.\n"); + return -ENODEV; } #endif
Gah, I recall fixing this at least twice. Somehow that didn't get pushed out. I'll commit this bit separately whilst I'm waiting for the description of the other patch.
Thanks,
Dave
Signature · 1 line
http://www.codemonkey.org.uk