Open Firmware serial port driver
Subsystems (2)
PATCH 1/1 Open Firmware serial port driver
This can be used for serial ports that are connected to an OF platform bus but are not autodetected by the lecacy serial support.
It will automatically take over devices that come from the legacy serial detection, which usually is only one device.
In some cases, rtas may be set up to use the serial port in the firmware, which allows easier debugging before probing the serial ports. In this case, the "used-by-rtas" property must be set by the firmware. This patch also adds code to the legacy serial driver to check for this.
---
Who will handle this driver? It is powerpc specific and hooks into powerpc code at one place, but it's also a new driver for the (orphaned) serial layer.
Could either Paul or Andrew merge this, or whoever else feels responsible?
arch/powerpc/kernel/legacy_serial.c | 15 + drivers/serial/Kconfig | 10 + drivers/serial/Makefile | 1 drivers/serial/of_serial.c | 143 ++++++++++++++++ 4 files changed, 169 insertions(+)
drivers/serial/Makefile +1 -0
@@ -58,3 +58,4 @@ obj-$(CONFIG_SERIAL_SGI_IOC3) += ioc3_se obj-$(CONFIG_SERIAL_ATMEL) += atmel_serial.o obj-$(CONFIG_SERIAL_UARTLITE) += uartlite.o obj-$(CONFIG_SERIAL_NETX) += netx-serial.o +obj-$(CONFIG_SERIAL_OF_PLATFORM) += of_serial.o
drivers/serial/of_serial.c new file +143 -0
143 lines not on this page · raw message
drivers/serial/Kconfig +10 -0
@@ -999,4 +999,14 @@ config SERIAL_NETX_CONSOLE If you have enabled the serial port on the Motorola IMX CPU you can make it the console by answering Y to this option. +config SERIAL_OF_PLATFORM + tristate "Serial port on Open Firmware platform bus" + depends on PPC_OF + depends on SERIAL_8250 + help + If you have a PowerPC based system that has serial ports + on a platform specific bus, you should enable this option. + Currently, only 8250 compatible ports are supported, but + others can easily be added. + endmenu
arch/powerpc/kernel/legacy_serial.c +15 -0
@@ -124,6 +124,10 @@ static int __init add_legacy_soc_port(stif (get_property (np,"clock-frequency" ,NULL ) ==NULL )return -1 ; +/* if rtas uses this device, don't try to use it as well */ +if (get_property (np,"used-by-rtas" ,NULL ) !=NULL ) +return -1 ; +/* Get the address */ addrp =of_get_address (soc_dev,0 ,NULL ,NULL );if (addrp ==NULL )
@@ -334,6 +338,17 @@ void __init find_legacy_serial_ports(voiof_node_put (tsi); } +/* First fill our array with opb bus ports */ +for (np =NULL ; (np =of_find_compatible_node (np,"serial" ,"ns16750" )) !=NULL ;) { +struct device_node *opb =of_get_parent (np); +if (opb && !strcmp (opb->type,"opb" )) { + index =add_legacy_soc_port (np, np); +if (index >=0 && np == stdout) + legacy_serial_console = index; + } +of_node_put (opb); + } +#ifdef CONFIG_PCI /* Next, try to locate PCI ports */ for (np =NULL ; (np =of_find_all_nodes (np));) {