Skip to contentSkip to conversation

adjust legacy IDE resource setting (v2)

PATCH In review Jan Beulich 2 participants 2 messages Feb 15, 2007 – Feb 19, 2007 PCI

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 adjust legacy IDE resource setting (v2)

The change to force legacy mode IDE channels' resources to fixed non-zero values confuses (at least some versions of) X, because the values reported by the kernel and those readable from PCI config space aren't consistent anymore. Therefore, this patch arranges for the respective BARs to also get updated if possible.

(The only change to the original version is an added comment.)

drivers/pci/probe.c +32 -13
@@ -639,7 +639,34 @@ static void pci_read_irq(struct pci_dev 
 	dev->irq = irq;
 }
 
-#define LEGACY_IO_RESOURCE	(IORESOURCE_IO | IORESOURCE_PCI_FIXED)
+static void change_legacy_io_resource(struct pci_dev * dev, unsigned index,
+                                      unsigned start, unsigned end)
+{
+	unsigned base = start & PCI_BASE_ADDRESS_IO_MASK;
+	unsigned len = (end | ~PCI_BASE_ADDRESS_IO_MASK) - base + 1;
+
+	/*
+	 * Some X versions get confused when the BARs reported through
+	 * /sys or /proc differ from those seen in config space, thus
+	 * try to update the config space values, too.
+	 */
+	if (!(pci_resource_flags(dev, index) & IORESOURCE_IO))
+		printk(KERN_WARNING "%s: cannot adjust BAR%u (not I/O)\n",
+		       pci_name(dev), index);
+	else if (pci_resource_len(dev, index) != len)
+		printk(KERN_WARNING "%s: cannot adjust BAR%u (size %04X)\n",
+		       pci_name(dev), index, (unsigned)pci_resource_len(dev, index));
+	else {
+		printk(KERN_INFO "%s: trying to change BAR%u from %04X to %04X\n",
+		       pci_name(dev), index,
+		       (unsigned)pci_resource_start(dev, index), base);
+		pci_write_config_dword(dev, PCI_BASE_ADDRESS_0 + index * 4, base);
+	}
+	pci_resource_start(dev, index) = start;
+	pci_resource_end(dev, index)   = end;
+	pci_resource_flags(dev, index) =
+		IORESOURCE_IO | IORESOURCE_PCI_FIXED | PCI_BASE_ADDRESS_SPACE_IO;
+}
 
 /**
  * pci_setup_device - fill in class and map information of a device
@@ -692,20 +719,12 @@ static int pci_setup_device(struct pci_d
 			u8 progif;
 			pci_read_config_byte(dev, PCI_CLASS_PROG, &progif);
 			if ((progif & 1) == 0) {
-				dev->resource[0].start = 0x1F0;
-				dev->resource[0].end = 0x1F7;
-				dev->resource[0].flags = LEGACY_IO_RESOURCE;
-				dev->resource[1].start = 0x3F6;
-				dev->resource[1].end = 0x3F6;
-				dev->resource[1].flags = LEGACY_IO_RESOURCE;
+				change_legacy_io_resource(dev, 0, 0x1F0, 0x1F7);
+				change_legacy_io_resource(dev, 1, 0x3F6, 0x3F6);
 			}
 			if ((progif & 4) == 0) {
-				dev->resource[2].start = 0x170;
-				dev->resource[2].end = 0x177;
-				dev->resource[2].flags = LEGACY_IO_RESOURCE;
-				dev->resource[3].start = 0x376;
-				dev->resource[3].end = 0x376;
-				dev->resource[3].flags = LEGACY_IO_RESOURCE;
+				change_legacy_io_resource(dev, 2, 0x170, 0x177);
+				change_legacy_io_resource(dev, 3, 0x376, 0x376);
 			}
 		}
 		break;
Acked-by on v1 1/1
#1 lore raw
Quoted 9 lines · Jan Beulich

The change to force legacy mode IDE channels' resources to fixed non-zero values confuses (at least some versions of) X, because the values reported by the kernel and those readable from PCI config space aren't consistent anymore. Therefore, this patch arranges for the respective BARs to also get updated if possible.

(The only change to the original version is an added comment.)

Quoted 65 lines
drivers/pci/probe.c +32 -13
@@ -639,7 +639,34 @@ static void pci_read_irq(struct pci_dev 
 	dev->irq = irq;
 }
 
-#define LEGACY_IO_RESOURCE	(IORESOURCE_IO | IORESOURCE_PCI_FIXED)
+static void change_legacy_io_resource(struct pci_dev * dev, unsigned index,
+                                      unsigned start, unsigned end)
+{
+	unsigned base = start & PCI_BASE_ADDRESS_IO_MASK;
+	unsigned len = (end | ~PCI_BASE_ADDRESS_IO_MASK) - base + 1;
+
+	/*
+	 * Some X versions get confused when the BARs reported through
+	 * /sys or /proc differ from those seen in config space, thus
+	 * try to update the config space values, too.
+	 */
+	if (!(pci_resource_flags(dev, index) & IORESOURCE_IO))
+		printk(KERN_WARNING "%s: cannot adjust BAR%u (not I/O)\n",
+		       pci_name(dev), index);
+	else if (pci_resource_len(dev, index) != len)
+		printk(KERN_WARNING "%s: cannot adjust BAR%u (size %04X)\n",
+		       pci_name(dev), index, (unsigned)pci_resource_len(dev, index));
+	else {
+		printk(KERN_INFO "%s: trying to change BAR%u from %04X to %04X\n",
+		       pci_name(dev), index,
+		       (unsigned)pci_resource_start(dev, index), base);
+		pci_write_config_dword(dev, PCI_BASE_ADDRESS_0 + index * 4, base);
+	}
+	pci_resource_start(dev, index) = start;
+	pci_resource_end(dev, index)   = end;
+	pci_resource_flags(dev, index) =
+		IORESOURCE_IO | IORESOURCE_PCI_FIXED | PCI_BASE_ADDRESS_SPACE_IO;
+}
 
 /**
  * pci_setup_device - fill in class and map information of a device
@@ -692,20 +719,12 @@ static int pci_setup_device(struct pci_d
 			u8 progif;
 			pci_read_config_byte(dev, PCI_CLASS_PROG, &progif);
 			if ((progif & 1) == 0) {
-				dev->resource[0].start = 0x1F0;
-				dev->resource[0].end = 0x1F7;
-				dev->resource[0].flags = LEGACY_IO_RESOURCE;
-				dev->resource[1].start = 0x3F6;
-				dev->resource[1].end = 0x3F6;
-				dev->resource[1].flags = LEGACY_IO_RESOURCE;
+				change_legacy_io_resource(dev, 0, 0x1F0, 0x1F7);
+				change_legacy_io_resource(dev, 1, 0x3F6, 0x3F6);
 			}
 			if ((progif & 4) == 0) {
-				dev->resource[2].start = 0x170;
-				dev->resource[2].end = 0x177;
-				dev->resource[2].flags = LEGACY_IO_RESOURCE;
-				dev->resource[3].start = 0x376;
-				dev->resource[3].end = 0x376;
-				dev->resource[3].flags = LEGACY_IO_RESOURCE;
+				change_legacy_io_resource(dev, 2, 0x170, 0x177);
+				change_legacy_io_resource(dev, 3, 0x376, 0x376);
 			}
 		}
 		break;
Signature · 5 lines
--
	In Ximian did mad Miguel a mighty mail client decree
	Where Nat the crazy hacker ran
	Through sourcecode measureless to man
	And never coredump free