hwmon/smsc47m1: Add support for the LPC47M292
Subsystems (2)
PATCH 1/1 hwmon/smsc47m1: Add support for the LPC47M292
The new SMSC LPC47M292 Super-I/O chip is a bit different from the previous ones, it supports a 3rd fan, but unfortunately the pin configuration registers are different.
Signed-off-by Jean Delvare <khali at linux-fr.org>
--- Documentation/hwmon/smsc47m1 | 11 ++- drivers/hwmon/Kconfig | 9 +- drivers/hwmon/smsc47m1.c | 160 +++++++++++++++++++++++++++++++++--------- 3 files changed, 139 insertions(+), 41 deletions(-)
Documentation/hwmon/smsc47m1 +8 -3
@@ -14,6 +14,10 @@ Supported chips: http://www.smsc.com/main/datasheets/47m14x.pdf http://www.smsc.com/main/tools/discontinued/47m15x.pdf http://www.smsc.com/main/datasheets/47m192.pdf + * SMSC LPC47M292 + Addresses scanned: none, address read from Super I/O config space + Prefix: 'smsc47m2' + Datasheet: Not public * SMSC LPC47M997 Addresses scanned: none, address read from Super I/O config space Prefix: 'smsc47m1'
@@ -32,9 +36,10 @@ Description The Standard Microsystems Corporation (SMSC) 47M1xx Super I/O chips contain monitoring and PWM control circuitry for two fans. -The 47M15x and 47M192 chips contain a full 'hardware monitoring block' -in addition to the fan monitoring and control. The hardware monitoring -block is not supported by the driver. +The LPC47M15x, LPC47M192 and LPC47M292 chips contain a full 'hardware +monitoring block' in addition to the fan monitoring and control. The +hardware monitoring block is not supported by this driver, use the +smsc47m192 driver for that. No documentation is available for the 47M997, but it has the same device ID as the 47M15x and 47M192 chips and seems to be compatible.
drivers/hwmon/Kconfig +5 -4
@@ -422,11 +422,12 @@ config SENSORS_SMSC47M1 If you say yes here you get support for the integrated fan monitoring and control capabilities of the SMSC LPC47B27x, LPC47M10x, LPC47M112, LPC47M13x, LPC47M14x, LPC47M15x, - LPC47M192 and LPC47M997 chips. + LPC47M192, LPC47M292 and LPC47M997 chips. - The temperature and voltage sensor features of the LPC47M192 - and LPC47M997 are supported by another driver, select also - "SMSC LPC47M192 and compatibles" below for those. + The temperature and voltage sensor features of the LPC47M15x, + LPC47M192, LPC47M292 and LPC47M997 are supported by another + driver, select also "SMSC LPC47M192 and compatibles" below for + those. This driver can also be built as a module. If so, the module will be called smsc47m1.
drivers/hwmon/smsc47m1.c +126 -34
319 lines not on this page · raw message
Signature · 1 line
Jean Delvare