Skip to contentSkip to conversation

Problem

LARTC Michael Flower 2 participants 2 messages Mar 13, 2007 – Mar 17, 2007

lore
Share & tools
lore
#0 lore raw

Hello.

I am trying to get multi paths running, i.e I want to specify 2 paths from a particular node to another.

To test this, I am setting up the following scenario:

I create 2 tap devices

    tap0 = 10.1.1.1/32 netmask 255.255.255.0
    tap1 = 10.2.2.2/32 netmask 255.255.255.0

I then issue the route command:

ip route add 10.3.3.3/32 nexthop via 10.1.1.2 nexthop via 10.2.2.3

The route table then looks like:

10.3.3.3

        nexthop via 10.1.1.2  dev tap0 weight 1
        nexthop via 10.2.2.3  dev tap1 weight 1

Pinging 10.3.3.3 causes arp requests on tap1 for 10.2.2.3 and never for 10.1.1.2.
(there is nothing connected to tap0 or tap1 so I don't expect anything really, but I do expect the ARP requests, which would show that splitting would work.

If the two routes were being used equally, I would have expected to see arp requests for 10.1.1.2 also (wouldn't I?)

...Michael Flower

Signature · 9 lines
Michael Flower
ES Labs
Elantis Systems Inc.
+61 3 9550 0866

_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
#1 lore raw
Quoted 21 lines · Michael Flower

Hello.

I am trying to get multi paths running, i.e I want to specify 2 paths from a particular node to another.

To test this, I am setting up the following scenario:

I create 2 tap devices

    tap0 = 10.1.1.1/32 netmask 255.255.255.0
    tap1 = 10.2.2.2/32 netmask 255.255.255.0

I then issue the route command:

ip route add 10.3.3.3/32 nexthop via 10.1.1.2 nexthop via 10.2.2.3

The route table then looks like:

10.3.3.3

        nexthop via 10.1.1.2  dev tap0 weight 1
        nexthop via 10.2.2.3  dev tap1 weight 1
Quoted 8 lines

Pinging 10.3.3.3 causes arp requests on tap1 for 10.2.2.3 and never for 10.1.1.2.
(there is nothing connected to tap0 or tap1 so I don't expect anything really, but I do expect the ARP requests, which would show that splitting would work.

If the two routes were being used equally, I would have expected to see arp requests for 10.1.1.2 also (wouldn't I?)

no, route uses src_ip+dst_ip+TOS to build it's cache, so it will use the same cached routing desicion unless you change one of these 3 parameters. After cache expires, probably the other hop takes it's turn.

Signature · 5 lines
Luciano
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc