: Always use debug-toggle parameters

Currently debugging output (when configured) is automatically enabled when DCCP modules are compiled into the kernel rather than built as loadable modules. This is not necessary, since the module parameters in this case become kernel commandline parameters, e.g. DCCP or CCID3 debug output can be enabled for a static build by appending the following at the boot prompt:

	dccp.dccp_debug=1 	dccp_ccid3.ccid3_debug=1

This patch therefore does away with the more complicated way of always enabling debug output for static builds

---
 net/dccp/dccp.h |    4 ----
 1 files changed, 0 insertions(+), 4 deletions(-)

index 2c5be61..a1768f5 100644
@@ -31,13 +31,9 @@
 					      __stringify(cond));          \
 			     } while (0)
 
-#ifdef MODULE
 #define DCCP_PRINTK(enable, fmt, args...)	do { if (enable)	     \
 							printk(fmt, ##args); \
 						} while(0)
-#else
-#define DCCP_PRINTK(enable, fmt, args...)	printk(fmt, ##args)
-#endif
 #define DCCP_PR_DEBUG(enable, fmt, a...)	DCCP_PRINTK(enable, KERN_DEBUG \
 						  "%s: " fmt, __FUNCTION__, ##a)
 

1.5.0.3