drivers/scsi/ips.c: remove kernel 2.4 code

@@ -58,10 +58,6 @@
    /*
     * Some handy macros
     */
-   #if LINUX_VERSION_CODE >= KERNEL_VERSION(2,4,20) || defined CONFIG_HIGHIO
-      #define IPS_HIGHIO
-   #endif
-
    #define IPS_HA(x)                   ((ips_ha_t *) x->hostdata)
    #define IPS_COMMAND_ID(ha, scb)     (int) (scb - ha->scbs)
    #define IPS_IS_TROMBONE(ha)         (((ha->device_id == IPS_DEVICEID_COPPERHEAD) && \

@@ -84,38 +80,8 @@
     #define IPS_SGLIST_SIZE(ha)       (IPS_USE_ENH_SGLIST(ha) ? \
                                          sizeof(IPS_ENH_SG_LIST) : sizeof(IPS_STD_SG_LIST))
 
-   #if LINUX_VERSION_CODE < KERNEL_VERSION(2,4,4)
-      #define pci_set_dma_mask(dev,mask) ( mask > 0xffffffff ? 1:0 )
-      #define scsi_set_pci_device(sh,dev) (0)
-   #endif
-
-   #ifndef IRQ_NONE
-      typedef void irqreturn_t;
-      #define IRQ_NONE
-      #define IRQ_HANDLED
-      #define IRQ_RETVAL(x)
-   #endif
-   
-   #if LINUX_VERSION_CODE < KERNEL_VERSION(2,5,0)
-      #define IPS_REGISTER_HOSTS(SHT)      scsi_register_module(MODULE_SCSI_HA,SHT)
-      #define IPS_UNREGISTER_HOSTS(SHT)    scsi_unregister_module(MODULE_SCSI_HA,SHT)
-      #define IPS_ADD_HOST(shost,device)
-      #define IPS_REMOVE_HOST(shost)
-      #define IPS_SCSI_SET_DEVICE(sh,ha)   scsi_set_pci_device(sh, (ha)->pcidev)
-      #define IPS_PRINTK(level, pcidev, format, arg...)                 \
-            printk(level "%s %s:" format , "ips" ,     \
-            (pcidev)->slot_name , ## arg)
-      #define scsi_host_alloc(sh,size)         scsi_register(sh,size)
-      #define scsi_host_put(sh)             scsi_unregister(sh)
-   #else
-      #define IPS_REGISTER_HOSTS(SHT)      (!ips_detect(SHT))
-      #define IPS_UNREGISTER_HOSTS(SHT)
-      #define IPS_ADD_HOST(shost,device)   do { scsi_add_host(shost,device); scsi_scan_host(shost); } while (0)
-      #define IPS_REMOVE_HOST(shost)       scsi_remove_host(shost)
-      #define IPS_SCSI_SET_DEVICE(sh,ha)   do { } while (0)
-      #define IPS_PRINTK(level, pcidev, format, arg...)                 \
+  #define IPS_PRINTK(level, pcidev, format, arg...)                 \
             dev_printk(level , &((pcidev)->dev) , format , ## arg)
-   #endif
 
    #define MDELAY(n)			\
 	do {				\

@@ -134,7 +100,7 @@
    #define pci_dma_hi32(a)         ((a >> 16) >> 16)
    #define pci_dma_lo32(a)         (a & 0xffffffff)
 
-   #if (BITS_PER_LONG > 32) || (defined CONFIG_HIGHMEM64G && defined IPS_HIGHIO)
+   #if (BITS_PER_LONG > 32) || defined(CONFIG_HIGHMEM64G)
       #define IPS_ENABLE_DMA64        (1)
    #else
       #define IPS_ENABLE_DMA64        (0)

@@ -451,16 +417,10 @@
    /*
     * Scsi_Host Template
     */
-#if LINUX_VERSION_CODE < KERNEL_VERSION(2,5,0)
-   static int ips_proc24_info(char *, char **, off_t, int, int, int);
-   static void ips_select_queue_depth(struct Scsi_Host *, struct scsi_device *);
-   static int ips_biosparam(Disk *disk, kdev_t dev, int geom[]);
-#else
    static int ips_proc_info(struct Scsi_Host *, char *, char **, off_t, int, int);
    static int ips_biosparam(struct scsi_device *sdev, struct block_device *bdev,
 		sector_t capacity, int geom[]);
    static int ips_slave_configure(struct scsi_device *SDptr);
-#endif
 
 /*
  * Raid Command Formats

309 lines not on this page · raw message