arkfb: New driver for ARK Logic cards

diff -uprN -X linux-2.6.21-rc7-mm2/Documentation/dontdiff linux-2.6.21-rc7-mm2/Documentation/fb/arkfb.txt linux-2.6.21-rc7-mm2-dev/Documentation/fb/arkfb.txt
@@ -0,0 +1,68 @@
+
+	arkfb - fbdev driver for ARK Logic chips
+	========================================
+
+
+Supported Hardware
+==================
+
+	ARK 2000PV chip
+	ICS 5342 ramdac
+
+	- only BIOS initialized VGA devices supported
+	- probably not working on big endian
+
+
+Supported Features
+==================
+
+	*  4 bpp pseudocolor modes (with 18bit palette, two variants)
+	*  8 bpp pseudocolor mode (with 18bit palette)
+	* 16 bpp truecolor modes (RGB 555 and RGB 565)
+	* 24 bpp truecolor mode (RGB 888)
+	* 32 bpp truecolor mode (RGB 888)
+	* text mode (activated by bpp = 0)
+	* doublescan mode variant (not available in text mode)
+	* panning in both directions
+	* suspend/resume support
+
+Text mode is supported even in higher resolutions, but there is limitation to
+lower pixclocks (i got maximum about 70 MHz, it is dependent on specific
+hardware). This limitation is not enforced by driver. Text mode supports 8bit
+wide fonts only (hardware limitation) and 16bit tall fonts (driver
+limitation). Unfortunately character attributes (like color) in text mode are
+broken for unknown reason, so its usefulness is limited.
+
+There are two 4 bpp modes. First mode (selected if nonstd == 0) is mode with
+packed pixels, high nibble first. Second mode (selected if nonstd == 1) is mode
+with interleaved planes (1 byte interleave), MSB first. Both modes support
+8bit wide fonts only (driver limitation).
+
+Suspend/resume works on systems that initialize video card during resume and
+if device is active (for example used by fbcon).
+
+
+Missing Features
+================
+(alias TODO list)
+
+	* secondary (not initialized by BIOS) device support
+   	* big endian support
+	* DPMS support
+	* MMIO support
+	* interlaced mode variant
+	* support for fontwidths != 8 in 4 bpp modes
+	* support for fontheight != 16 in text mode
+	* hardware cursor
+	* vsync synchronization
+	* feature connector support
+	* acceleration support (8514-like 2D)
+
+
+Known bugs
+==========
+
+	* character attributes (and cursor) in text mode are broken
+
+--
+Ondrej Zajicek <[email protected]>

diff -uprN -X linux-2.6.21-rc7-mm2/Documentation/dontdiff linux-2.6.21-rc7-mm2/drivers/video/Kconfig linux-2.6.21-rc7-mm2-dev/drivers/video/Kconfig
@@ -1412,6 +1412,20 @@ config FB_TRIDENT_ACCEL
 	This will compile the Trident frame buffer device with
 	acceleration functions.
 
+config FB_ARK
+	tristate "ARK 2000PV support"
+	depends on FB && PCI
+	select FB_CFB_FILLRECT
+	select FB_CFB_COPYAREA
+	select FB_CFB_IMAGEBLIT
+	select FB_TILEBLITTING
+	select FB_SVGALIB
+	select VGASTATE
+	select FONT_8x16 if FRAMEBUFFER_CONSOLE
+	---help---
+	  Driver for PCI graphics boards with ARK 2000PV chip
+	  and ICS 5342 RAMDAC.
+
 config FB_PM3
 	tristate "Permedia3 support"
 	depends on FB && PCI && BROKEN

diff -uprN -X linux-2.6.21-rc7-mm2/Documentation/dontdiff linux-2.6.21-rc7-mm2/drivers/video/Makefile linux-2.6.21-rc7-mm2-dev/drivers/video/Makefile
@@ -59,6 +59,7 @@ obj-$(CONFIG_FB_CYBLA)            += cyb
 obj-$(CONFIG_FB_TRIDENT)          += tridentfb.o
 obj-$(CONFIG_FB_LE80578)          += vermilion/
 obj-$(CONFIG_FB_S3)               += s3fb.o
+obj-$(CONFIG_FB_ARK)              += arkfb.o
 obj-$(CONFIG_FB_STI)              += stifb.o
 obj-$(CONFIG_FB_FFB)              += ffb.o sbuslib.o
 obj-$(CONFIG_FB_CG6)              += cg6.o sbuslib.o