powerpc: remove unused do_signal export

PATCH New Christoph Hellwig 1 participant 1 message May 29, 2007 PowerPC

lore

Share & tools

lore

Christoph Hellwig

author

2007-05-29 11:49 UTC #0 lore raw

PATCH 1/1 powerpc: remove unused do_signal export

do_signal is never used in modular code (obviously), and not other architecture exports it either.

Signed-off-by Christoph Hellwig <[email protected]>

arch/powerpc/kernel/ppc_ksyms.c +0 -1

Index: linux-2.6/arch/powerpc/kernel/ppc_ksyms.c
===================================================================
@@ -67,7 +67,6 @@ EXPORT_SYMBOL(ISA_DMA_THRESHOLD);
 EXPORT_SYMBOL(DMA_MODE_READ);
 EXPORT_SYMBOL(DMA_MODE_WRITE);
 
-EXPORT_SYMBOL(do_signal);
 EXPORT_SYMBOL(transfer_to_handler);
 EXPORT_SYMBOL(do_IRQ);
 EXPORT_SYMBOL(machine_check_exception);

arch/powerpc/kernel/signal_64.c +0 -1

Index: linux-2.6/arch/powerpc/kernel/signal_64.c
===================================================================
@@ -568,4 +568,3 @@ int do_signal(sigset_t *oldset, struct p
 
 	return 0;
 }
-EXPORT_SYMBOL(do_signal);

arch/ppc/kernel/ppc_ksyms.c +0 -1

Index: linux-2.6/arch/ppc/kernel/ppc_ksyms.c
===================================================================
@@ -65,7 +65,6 @@ extern unsigned long mm_ptov (unsigned l
 
 EXPORT_SYMBOL(clear_pages);
 EXPORT_SYMBOL(clear_user_page);
-EXPORT_SYMBOL(do_signal);
 EXPORT_SYMBOL(transfer_to_handler);
 EXPORT_SYMBOL(do_IRQ);
 EXPORT_SYMBOL(machine_check_exception);