ide: remove stale changelog/comments/TODO from ide.c
PATCH 14/15 ide: remove stale changelog/comments/TODO from ide.c
Signed-off-by Bartlomiej Zolnierkiewicz <[email protected]>
--- drivers/ide/ide.c | 78 ------------------------------------------------------ 1 file changed, 78 deletions(-)
drivers/ide/ide.c +0 -78
@@ -16,10 +16,6 @@* (usually 14 & 15). * There can be up to two drives per interface, as per the ATA-2 spec. * -* Primary: ide0, port 0x1f0; major=3; hda is minor=0; hdb is minor=64 -* Secondary: ide1, port 0x170; major=22; hdc is minor=0; hdd is minor=64 -* Tertiary: ide2, port 0x???; major=33; hde is minor=0; hdf is minor=64 -* Quaternary: ide3, port 0x???; major=34; hdg is minor=0; hdh is minor=64 * ... * * From hd.c:
@@ -47,80 +43,6 @@* This was a rewrite of just about everything from hd.c, though some original * code is still sprinkled about. Think of it as a major evolution, with * inspiration from lots of linux users, esp. [email protected] -* -* Version 1.0 ALPHA initial code, primary i/f working okay -* Version 1.3 BETA dual i/f on shared irq tested & working! -* Version 1.4 BETA added auto probing for irq(s) -* Version 1.5 BETA added ALPHA (untested) support for IDE cd-roms, -* ... -* Version 5.50 allow values as small as 20 for idebus= -* Version 5.51 force non io_32bit in drive_cmd_intr() -* change delay_10ms() to delay_50ms() to fix problems -* Version 5.52 fix incorrect invalidation of removable devices -* add "hdx=slow" command line option -* Version 5.60 start to modularize the driver; the disk and ATAPI -* drivers can be compiled as loadable modules. -* move IDE probe code to ide-probe.c -* move IDE disk code to ide-disk.c -* add support for generic IDE device subdrivers -* add m68k code from Geert Uytterhoeven -* probe all interfaces by default -* add ioctl to (re)probe an interface -* Version 6.00 use per device request queues -* attempt to optimize shared hwgroup performance -* add ioctl to manually adjust bandwidth algorithms -* add kerneld support for the probe module -* fix bug in ide_error() -* fix bug in the first ide_get_lock() call for Atari -* don't flush leftover data for ATAPI devices -* Version 6.01 clear hwgroup->active while the hwgroup sleeps -* support HDIO_GETGEO for floppies -* Version 6.02 fix ide_ack_intr() call -* check partition table on floppies -* Version 6.03 handle bad status bit sequencing in ide_wait_stat() -* Version 6.10 deleted old entries from this list of updates -* replaced triton.c with ide-dma.c generic PCI DMA -* added support for BIOS-enabled UltraDMA -* rename all "promise" things to "pdc4030" -* fix EZ-DRIVE handling on small disks -* Version 6.11 fix probe error in ide_scan_devices() -* fix ancient "jiffies" polling bugs -* mask all hwgroup interrupts on each irq entry -* Version 6.12 integrate ioctl and proc interfaces -* fix parsing of "idex=" command line parameter -* Version 6.13 add support for ide4/ide5 courtesy [email protected] -* Version 6.14 fixed IRQ sharing among PCI devices -* Version 6.15 added SMP awareness to IDE drivers -* Version 6.16 fixed various bugs; even more SMP friendly -* Version 6.17 fix for newest EZ-Drive problem -* Version 6.18 default unpartitioned-disk translation now "BIOS LBA" -* Version 6.19 Re-design for a UNIFORM driver for all platforms, -* model based on suggestions from Russell King and -* Geert Uytterhoeven -* Promise DC4030VL now supported. -* add support for ide6/ide7 -* delay_50ms() changed to ide_delay_50ms() and exported. -* Version 6.20 Added/Fixed Generic ATA-66 support and hwif detection. -* Added hdx=flash to allow for second flash disk -* detection w/o the hang loop. -* Added support for ide8/ide9 -* Added idex=ata66 for the quirky chipsets that are -* ATA-66 compliant, but have yet to determine a method -* of verification of the 80c cable presence. -* Specifically Promise's PDC20262 chipset. -* Version 6.21 Fixing/Fixed SMP spinlock issue with insight from an old -* hat that clarified original low level driver design. -* Version 6.30 Added SMP support; fixed multmode issues. -ml -* Version 6.31 Debug Share INTR's and request queue streaming -* Native ATA-100 support -* Prep for Cascades Project -* Version 7.00alpha First named revision of ide rearrange -* -* Some additional driver compile-time options are in ./include/linux/ide.h -* -* To do, in likely order of completion: -* - modify kernel to obtain BIOS geometry for drives on 2nd/3rd/4th i/f -* */ #define REVISION "Revision: 7.00alpha2"