it8213: PIO fixes
PATCH 5/12 it8213: PIO fixes
* Rename it8213_tuneproc() to it8213_tune_pio() and add it8213_tuneproc() wrapper. Move finding of the best PIO mode to the new wrapper.
* Add setting of transfer mode on the device to it8213_tuneproc().
* Don't call it8213_dma_2_pio() for PIO modes in it8213_tune_chipset().
* Use it8213_tuneproc() in it8213_config_drive_for_dma().
--- drivers/ide/pci/it8213.c | 25 ++++++++++++++++--------- 1 file changed, 16 insertions(+), 9 deletions(-)
drivers/ide/pci/it8213.c +16 -9
@@ -55,14 +55,14 @@ static u8 it8213_dma_2_pio (u8 xfer_rate }/* -* it8213_tuneproc - tune a drive +* it8213_tune_pio - tune a drive * @drive: drive to tune * @pio: desired PIO mode * * Set the interface PIO mode. */ -static void it8213_tuneproc (ide_drive_t *drive,u8 pio) +static void it8213_tune_pio (ide_drive_t *drive,const u8 pio) {ide_hwif_t *hwif =HWIF (drive);struct pci_dev *dev = hwif->pci_dev;
@@ -82,8 +82,6 @@ static void it8213_tuneproc (ide_drive_t { 2, 1 }, { 2, 3 }, }; - pio =ide_get_best_pio_mode (drive, pio,4 ); -spin_lock_irqsave (&tune_lock, flags);pci_read_config_word (dev, master_port, &master_data);
@@ -113,6 +111,13 @@ static void it8213_tuneproc (ide_drive_tspin_unlock_irqrestore (&tune_lock, flags); } +static void it8213_tuneproc (ide_drive_t *drive,u8 pio) +{ + pio =ide_get_best_pio_mode (drive, pio,4 ); +it8213_tune_pio (drive, pio); +ide_config_drive_speed (drive,XFER_PIO_0 + pio); +} +/** * it8213_tune_chipset - set controller timings * @drive: Drive to set up
@@ -193,7 +198,12 @@ static int it8213_tune_chipset (ide_drivif (reg55 & w_flag)pci_write_config_byte (dev,0x55 , (u8 ) reg55 & ~w_flag); } -it8213_tuneproc (drive,it8213_dma_2_pio (speed)); + +if (speed >XFER_PIO_4 ) +it8213_tune_pio (drive,it8213_dma_2_pio (speed)); +else +it8213_tune_pio (drive, speed -XFER_PIO_0 ); +return ide_config_drive_speed (drive, speed); }
@@ -209,13 +219,10 @@ static int it8213_tune_chipset (ide_drivstatic int it8213_config_drive_for_dma (ide_drive_t *drive) { -u8 pio; -if (ide_tune_dma (drive))return 0 ; - pio =ide_get_best_pio_mode (drive,255 ,4 ); -it8213_tune_chipset (drive,XFER_PIO_0 + pio); +it8213_tuneproc (drive,255 );return -1 ; }
Quoted 6 lines · Bartlomiej Zolnierkiewicz
* Rename
it8213_tuneproc()toit8213_tune_pio()and addit8213_tuneproc()wrapper. Move finding of the best PIO mode to the new wrapper.* Add setting of transfer mode on the device to
it8213_tuneproc().* Don't call
it8213_dma_2_pio()for PIO modes init8213_tune_chipset().
Again, XFER_PIO_* switch cases might have been be deleted fromit8213_dma_2_pio() then... Though the idea was to part with this function completely -- to be done yet...
Quoted 3 lines
* Use
it8213_tuneproc()init8213_config_drive_for_dma().Signed-off-by Bartlomiej Zolnierkiewicz <[email protected]>
MBR, Sergei
Quoted 5 lines · Sergei Shtylyov
Quoted 2 lines · Bartlomiej Zolnierkiewicz
* Rename
it8213_tuneproc()toit8213_tune_pio()and addit8213_tuneproc()wrapper. Move finding of the best PIO mode to the new wrapper.
Quoted 7 lines
Quoted 3 lines
* Add setting of transfer mode on the device to
it8213_tuneproc().* Don't call
it8213_dma_2_pio()for PIO modes init8213_tune_chipset().Again, XFER_PIO_* switch cases might have been be deleted from
it8213_dma_2_pio()then... Though the idea was to part with this function completely -- to be done yet...
yes TBD :)
Quoted 5 lines
Quoted 3 lines
* Use
it8213_tuneproc()init8213_config_drive_for_dma().Signed-off-by Bartlomiej Zolnierkiewicz <[email protected]>Acked-by Sergei Shtylyov <[email protected]>
added