Skip to contentSkip to conversation

ide-pmac: use ide_tune_dma()

PATCH Bartlomiej Zolnierkiewicz 1 participant 1 message Jul 23, 2007

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

* Add missing initialization of hwif->autodma and drive->autodma to pmac_ide_setup_dma().

* Use ide_tune_dma() in pmac_ide_dma_check().

While at it:

* Fix pmac_ide_dma_check() return value if DMA mode is not programmed (should be "-1" otherwise ide_set_dma() will try to enable DMA).

* Remove unnecessary drive->using_dma fiddling (->dma_off_quietly is always called before ide_set_dma() call and ide_set_dma() calls ->ide_dma_on if ->ide_dma_check returns "0").

---
bonus patch ;)

 drivers/ide/ppc/pmac.c |   24 +++++++-----------------
 1 file changed, 7 insertions(+), 17 deletions(-)
drivers/ide/ppc/pmac.c +7 -17
Index: b/drivers/ide/ppc/pmac.c
===================================================================
@@ -1592,23 +1592,10 @@ pmac_ide_destroy_dmatable (ide_drive_t *
 static int
 pmac_ide_dma_check(ide_drive_t *drive)
 {
-	int enable = 1;
-	drive->using_dma = 0;
-	
-	if (drive->media == ide_floppy)
-		enable = 0;
-	if ((drive->id->capability & 1) == 0 && !__ide_dma_good_drive(drive))
-		enable = 0;
-	if (__ide_dma_bad_drive(drive))
-		enable = 0;
-
-	if (enable) {
-		u8 mode = ide_max_dma_mode(drive);
+	if (drive->media != ide_floppy && ide_tune_dma(drive))
+		return 0;
 
-		if (mode && pmac_ide_tune_chipset(drive, mode) == 0)
-			drive->using_dma = 1;
-	}
-	return 0;
+	return -1;
 }
 
 /*
@@ -1842,7 +1829,10 @@ pmac_ide_setup_dma(pmac_ide_hwif_t *pmif
 			hwif->mwdma_mask = 0x07;
 			hwif->swdma_mask = 0x00;
 			break;
-	}	
+	}
+
+	hwif->autodma = 1;
+	hwif->drives[1].autodma = hwif->drives[0].autodma = hwif->autodma;
 }
 
 #endif /* CONFIG_BLK_DEV_IDEDMA_PMAC */