net: smc91x: Build fixes for general sh boards.

PATCH Applied Paul Mundt 2 participants 2 messages Aug 1, 2007 – Aug 7, 2007 Network drivers

Share & tools

Paul Mundt

author

2007-08-01 06:49 UTC #0 lore raw

PATCH 1/1 net: smc91x: Build fixes for general sh boards.

SH boards in general only wire this up in 8 or 16-bit mode, and as we never had the wrappers for 32-bit mode defined, SMC_CAN_USE_32BIT caused build failure for the non-Solution Engine boards. This gets it building again.

Also kill off the straggling set_irq_type() definition, this is left over cruft that was missed when the rest of it switched to IRQ flags.

Signed-off-by Paul Mundt <[email protected]>

 drivers/net/smc91x.h |    4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

drivers/net/smc91x.h +1 -3

index f842944..6ff3a16 100644
@@ -299,7 +299,7 @@ SMC_outw(u16 val, void __iomem *ioaddr, int reg)
 
 #define SMC_CAN_USE_8BIT       1
 #define SMC_CAN_USE_16BIT      1
-#define SMC_CAN_USE_32BIT      1
+#define SMC_CAN_USE_32BIT      0
 
 #define SMC_inb(a, r)          inb((a) + (r))
 #define SMC_inw(a, r)          inw((a) + (r))

@@ -310,8 +310,6 @@ SMC_outw(u16 val, void __iomem *ioaddr, int reg)
 
 #endif  /* BOARDS */
 
-#define set_irq_type(irq, type) do {} while (0)
-
 #elif   defined(CONFIG_M32R)
 
 #define SMC_CAN_USE_8BIT	0

Jeff Garzik

Applied

2007-08-07 21:41 UTC #1 lore raw

Quoted 9 lines · Paul Mundt

SH boards in general only wire this up in 8 or 16-bit mode, and as we never had the wrappers for 32-bit mode defined, SMC_CAN_USE_32BIT caused build failure for the non-Solution Engine boards. This gets it building again.
Also kill off the straggling set_irq_type() definition, this is left over cruft that was missed when the rest of it switched to IRQ flags.
Signed-off-by Paul Mundt <[email protected]>

applied to #upstream-fixes