Skip to contentSkip to conversation

emu10k1 ALSA/jack problem

DISCUSSION [email protected] 2 participants 2 messages Aug 10, 2007 – Aug 14, 2007

lore
Share & tools
lore
#0 lore raw

Dear All,

I am currently working on an audio program (aldrin) which uses libbzub driver
http://trac.zeitherrschaft.org/zzub/browser/trunk/src/libzzub/driver.cpp
for accessing the sound card. Libzzub, in turn uses rtaudio version 3.03, which is part of the libzzub source tree.

The problem arises when I am running a jack server using my sblive, but specifying the default interface (hw:0).

On startup, a vast number of xruns are generated (>200) and jack either falls over, or the computer almost completely locks up.

This appears to be caused by rtaudio probing the alsa devices whilst jack is running. Interestingly, if I specify a sub-device (hw:0,3), or the integrated sound card (intel), no xruns are generated.

I am wondering if this problem is arising because of a bug in the emu10k1 driver, or a problem with the way rtaudio probes alsa devices, or because it is a bad idea to probe alsa devices while they are being used by jack???

Best wishes,

James

#1 lore raw

At Fri, 10 Aug 2007 12:10:45 +0100,

Quoted 20 lines · [email protected] wrote:

Dear All,

I am currently working on an audio program (aldrin) which uses libbzub driver
http://trac.zeitherrschaft.org/zzub/browser/trunk/src/libzzub/driver.cpp
for accessing the sound card. Libzzub, in turn uses rtaudio version 3.03, which is part of the libzzub source tree.

The problem arises when I am running a jack server using my sblive, but specifying the default interface (hw:0).

On startup, a vast number of xruns are generated (>200) and jack either falls over, or the computer almost completely locks up.

This appears to be caused by rtaudio probing the alsa devices whilst jack is running. Interestingly, if I specify a sub-device (hw:0,3), or the integrated sound card (intel), no xruns are generated.

Quoted 4 lines

I am wondering if this problem is arising because of a bug in the emu10k1 driver, or a problem with the way rtaudio probes alsa devices, or because it is a bad idea to probe alsa devices while they are being used by jack???

It's hard to tell. In some cases, it's rahter a hardware setup (e.g. assining another PCI slot helps) and in some cases it's a software problem.

It's possible that concurrent access to hw:0,0 may hold long locks. Speciying hw:0,3 means that you're using another PCM device (the multi-channel PCM), so the lock is likely specific to the PCM stream. One difference between HD-audio and emu10k1 here is that emu10k1 has multiple (sub)streams while HD-audio has a single stream. Thus, opening the same device will result in a blocking on HD-audio while emu10k1 gives the next available substream.

Takashi