Skip to contentSkip to conversation

New: 3ware 9650SE -8LPML not recognized by 3w-9xxx driver

Bugme-new Andrew Morton 1 participant 1 message Aug 20, 2007 1 message not in the archive SCSI

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]/

#1 lore raw
Quoted 35 lines · On Sun, 19 Aug 2007 11:51:38 -0700 (PDT) [email protected] wrote:

http://bugzilla.kernel.org/show_bug.cgi?id=8908

Summary: 3ware 9650SE -8LPML not recognized by 3w-9xxx driver
Product: IO/Storage
Version: 2.5
KernelVersion: 2.6.20.1
Platform: All
OS/Version: Linux
Tree: Mainline
Status: NEW
Severity: high
Priority: P1
Component: Serial ATA
AssignedTo: [email protected]
ReportedBy: [email protected]

Most recent kernel where this bug did not occur:
Distribution: Debian Lenny/Sid
Hardware Environment: Intel Pentium D 820, Intel Mainboard with 955X Controller on board
Software Environment: Linux/Debian
Problem Description: The 3w-9xxx kernel driver for 3ware 9xxx SATA RAID Controller series did not recognize the 3ware 9650SE-8LPML SATA RAID Controller. I tryed also with original driver from 3ware itself, but this also didn't work, because of changes in module interface. If you need tester for this controller, i can do it for you.

Steps to reproduce: Get the mentioned card, install it in your compouter, and attach some sata hd's to it. Compile kernel with 3w-9xxx SATA RAID driver(SCSI section) and install it. Include HD's into your fstab.conf. Reboot and watch boot messages. You will see, that HD's, that are attached to the 3ware Controller are not found. After boot, put lspci into your linux console. lspci shows, here is an unrecognized 3ware Controller card.