Skip to contentSkip to conversation

r8169: can't send magic packet for Wake-On-Lan

DISCUSSION Xavier Bestel 2 participants 5 messages Sep 11, 2007 – Sep 13, 2007

lore
Share & tools
lore
#0 lore raw

Hi again,

with the r8169 I can't send a magic packet anymore. I'm using ethtool for that, with the previous one (an rtl8139b) it was working very well. ethtool -D apparently says it could send the packet ok.
The receiving side hasn't changed (it's an r8169 too), it's setup for wake-on-lan and is soft-powered-off with ACPI as it should (no change in config since a few years).

Do I have to set something special on the sending end ?

Thanks,

Xav

#1 lore raw

Xavier Bestel <[email protected]> :
[...]

Quoted 3 lines

with the r8169 I can't send a magic packet anymore. I'm using ethtool for that, with the previous one (an rtl8139b) it was working very well. ethtool -D apparently says it could send the packet ok.

I see no "-D" option in the sources from the git repository of ethtool.

Where did you find it ?

Signature · 1 line
Ueimor
#2 lore raw
Quoted 9 lines · Francois Romieu

Xavier Bestel <[email protected]> :
[...]

Quoted 3 lines

with the r8169 I can't send a magic packet anymore. I'm using ethtool for that, with the previous one (an rtl8139b) it was working very well. ethtool -D apparently says it could send the packet ok.

I see no "-D" option in the sources from the git repository of ethtool.

Where did you find it ?

Err sorry, I mixed up everything ... I'm using *etherwake* to make the WOL magic packet, and ethtool to check the interface options.

Xav

#3 lore raw

Xavier Bestel <[email protected]> :
[...]

Quoted 2 lines

Err sorry, I mixed up everything ... I'm using *etherwake* to make the WOL magic packet, and ethtool to check the interface options.

Weird.

Can you capture the traffic from the receiving (live) r8169 whith both senders and specify the kernel version of the sender/receiver ?

Signature · 1 line
Ueimor
#4 lore raw
Quoted 9 lines · Francois Romieu

Xavier Bestel <[email protected]> :
[...]

Quoted 2 lines

Err sorry, I mixed up everything ... I'm using *etherwake* to make the WOL magic packet, and ethtool to check the interface options.

Weird.

Can you capture the traffic from the receiving (live) r8169 whith both senders and specify the kernel version of the sender/receiver ?

Sorry for not following up: the packet arrives correctly to the receiving host when it's running, the problem is that it doesn't wake up. As I have changed the switch at the same time (gigabit upgrade) maybe when the host is powered off the switch doesn't forward the magic packet ?
I'll dig the old 10/100 hub and try again.

Thanks,
Xav