Skip to contentSkip to conversation

CM-x270: ITE 8152 PCI bridge support

PATCH In review Mike Rapoport 4 participants 5 messages Sep 20, 2007 – Sep 21, 2007

Subsystems (2)
Arm (32-bit) PCI
lore
Share & tools
lore

Mike Rapoport

author
#0 lore raw

PATCH 2/3 CM-x270: ITE 8152 PCI bridge support

This patch provides driver for ITE 8152 PCI bridge.

Signed-off-by Mike Rapoport <[email protected]>
 arch/arm/common/Makefile          |    1 +
 arch/arm/common/it8152.c          |  387 +++++++++++++++++++++++++++++++++++++
 arch/arm/kernel/bios32.c          |   28 +++-
 include/asm-arm/hardware/it8152.h |   99 ++++++++++
 include/asm-arm/pci.h             |    7 +
 include/linux/pci_ids.h           |    1 +
 6 files changed, 520 insertions(+), 3 deletions(-)
arch/arm/common/Makefile +1 -0
index e1289a2..3d0b9fa 100644
@@ -17,3 +17,4 @@ obj-$(CONFIG_SHARPSL_PM)	+= sharpsl_pm.o
 obj-$(CONFIG_SHARP_SCOOP)	+= scoop.o
 obj-$(CONFIG_ARCH_IXP2000)	+= uengine.o
 obj-$(CONFIG_ARCH_IXP23XX)	+= uengine.o
+obj-$(CONFIG_PCI_HOST_ITE8152)  += it8152.o
arch/arm/common/it8152.c new file +387 -0

387 lines not on this page · raw message

arch/arm/kernel/bios32.c +25 -3
index 240c448..cba32ee 100644
@@ -279,6 +279,25 @@ static void __devinit pci_fixup_cy82c693(struct pci_dev *dev)
 }
 DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_CONTAQ, PCI_DEVICE_ID_CONTAQ_82C693, pci_fixup_cy82c693);
 
+static void __init pci_fixup_it8152(struct pci_dev *dev)
+{
+	int i;
+	/* fixup for ITE 8152 devices */
+	/* FIXME: add defines for class 0x68000 and 0x80103 */
+	if ((dev->class >> 8) == PCI_CLASS_BRIDGE_HOST ||
+	    dev->class == 0x68000 ||
+	    dev->class == 0x80103) {
+		for (i = 0; i < PCI_NUM_RESOURCES; i++) {
+			dev->resource[i].start = 0;
+			dev->resource[i].end   = 0;
+			dev->resource[i].flags = 0;
+		}
+	}
+}
+DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_ITE, PCI_DEVICE_ID_ITE_8152, pci_fixup_it8152);
+
+
+
 void __devinit pcibios_update_irq(struct pci_dev *dev, int irq)
 {
 	if (debug_pci)

@@ -292,9 +311,12 @@ void __devinit pcibios_update_irq(struct pci_dev *dev, int irq)
  */
 static inline int pdev_bad_for_parity(struct pci_dev *dev)
 {
-	return (dev->vendor == PCI_VENDOR_ID_INTERG &&
-		(dev->device == PCI_DEVICE_ID_INTERG_2000 ||
-		 dev->device == PCI_DEVICE_ID_INTERG_2010));
+	return ((dev->vendor == PCI_VENDOR_ID_INTERG &&
+		 (dev->device == PCI_DEVICE_ID_INTERG_2000 ||
+		  dev->device == PCI_DEVICE_ID_INTERG_2010)) ||
+		(dev->vendor == PCI_VENDOR_ID_ITE &&
+		 dev->device == PCI_DEVICE_ID_ITE_8152));
+
 }
 
 /*
include/asm-arm/hardware/it8152.h new file +99 -0

99 lines not on this page · raw message

include/asm-arm/pci.h +7 -0
index ed3f898..75feb15 100644
@@ -8,10 +8,17 @@
 
 #define pcibios_scan_all_fns(a, b)	0
 
+#ifdef CONFIG_PCI_HOST_ITE8152
+/* ITE bridge requires setting latency timer to avoid early bus access
+   termination by PIC bus mater devices
+*/
+extern void pcibios_set_master(struct pci_dev *dev);
+#else
 static inline void pcibios_set_master(struct pci_dev *dev)
 {
 	/* No special bus mastering setup handling */
 }
+#endif
 
 static inline void pcibios_penalize_isa_irq(int irq, int active)
 {
include/linux/pci_ids.h +1 -0
index 55f307f..357390d 100644
@@ -1629,6 +1629,7 @@
 #define PCI_DEVICE_ID_ITE_8211		0x8211
 #define PCI_DEVICE_ID_ITE_8212		0x8212
 #define PCI_DEVICE_ID_ITE_8213		0x8213
+#define PCI_DEVICE_ID_ITE_8152		0x8152
 #define PCI_DEVICE_ID_ITE_8872		0x8872
 #define PCI_DEVICE_ID_ITE_IT8330G_0	0xe886
#1 lore raw
Quoted 6 lines · Mike Rapoport

This patch provides driver for ITE 8152 PCI bridge.

Signed-off-by Mike Rapoport <[email protected]>
 arch/arm/common/Makefile          |    1 +
 arch/arm/common/it8152.c          |  387 +++++++++++++++++++++++++++++++++++++

Shouldn't it go to drivers/pci and define a platform driver? it8152 is not an ARM specific controller.

Thanks
Guennadi
---------------------------------
Guennadi Liakhovetski, Ph.D.
DSA Daten- und Systemtechnik GmbH
Pascalstr. 28
D-52076 Aachen
Germany

#2 lore raw
Quoted 11 lines · Guennadi Liakhovetski
Quoted 6 lines · Mike Rapoport

This patch provides driver for ITE 8152 PCI bridge.

Signed-off-by Mike Rapoport <[email protected]>
 arch/arm/common/Makefile          |    1 +
 arch/arm/common/it8152.c          |  387 +++++++++++++++++++++++++++++++++++++

Shouldn't it go to drivers/pci and define a platform driver? it8152 is not an ARM specific controller.

drivers/pci is currently only used for the PCI bus infrastructure. The setup of host bridges is very platform dependent.

Also note that you should *avoid* DMA bounce wherever possible. The code is broken as designed. Ensure that the DMA mask is set appropriately, and then moan elsewhere if things don't work.

#3 lore raw
Quoted 13 lines · Russell King - ARM Linux
Quoted 11 lines · Guennadi Liakhovetski
Quoted 6 lines · Mike Rapoport

This patch provides driver for ITE 8152 PCI bridge.

Signed-off-by Mike Rapoport <[email protected]>
 arch/arm/common/Makefile          |    1 +
 arch/arm/common/it8152.c          |  387 +++++++++++++++++++++++++++++++++++++

Shouldn't it go to drivers/pci and define a platform driver? it8152 is not an ARM specific controller.

Quoted 6 lines

drivers/pci is currently only used for the PCI bus infrastructure. The setup of host bridges is very platform dependent.

Also note that you should *avoid* DMA bounce wherever possible. The code is broken as designed. Ensure that the DMA mask is set appropriately, and then moan elsewhere if things don't work.

That's more or less what I'm trying to do. ITE chip allows to address up to 64Mbyte, so I have to ensure that *no* PCI device will ever try to DMA above that limit.
I don't see other way to ensure it.

Quoted 5 lines

-------------------------------------------------------------------

List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm-kernel
FAQ:        http://www.arm.linux.org.uk/mailinglists/faq.php
Etiquette:  http://www.arm.linux.org.uk/mailinglists/etiquette.php
Signature · 2 lines
	Sincerely Yours,
		Mike.
#4 lore raw
In reply to Guennadi Liakhovetski
Quoted 11 lines · Guennadi Liakhovetski
Quoted 6 lines · Mike Rapoport

This patch provides driver for ITE 8152 PCI bridge.

Signed-off-by Mike Rapoport <[email protected]>
 arch/arm/common/Makefile          |    1 +
 arch/arm/common/it8152.c          |  387 +++++++++++++++++++++++++++++++++++++

Shouldn't it go to drivers/pci and define a platform driver? it8152 is not an ARM specific controller.

ITE 8152 is StrongArm and PXA255 companion chip. I can hardly imagine it's use with other architectures. Even making it work with PXA270 was pretty tough.

Quoted 15 lines

Thanks
Guennadi
---------------------------------
Guennadi Liakhovetski, Ph.D.
DSA Daten- und Systemtechnik GmbH
Pascalstr. 28
D-52076 Aachen
Germany

-------------------------------------------------------------------

List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm-kernel
FAQ:        http://www.arm.linux.org.uk/mailinglists/faq.php
Etiquette:  http://www.arm.linux.org.uk/mailinglists/etiquette.php
Signature · 2 lines
Sincerely Yours,
Mike.