Remove error message if die-code is missing
PATCH 1/1 Remove error message if die-code is missing
Hi all,
The simple patch below removes the error message if the die-code entry is missing in /sys. It has been removed from the 2.6 kernels for a long time.
It is still present for 2.4 kernels though, so we should keep the code reading this entry.
Regards,
Aurelien
Index: prog/sensors/chips.c
=================================--- prog/sensors/chips.c (révision 4862)
+++ prog/sensors/chips.c (copie de travail)
@@ -261,8 +261,7 @@
print_label(label,10);
printf("%4.0f\n",cur);
}
- } else
- printf("ERROR: Can't get die-code data!\n");
+ }
free(label); }
}
Signature · 9 lines
.''`. Aurelien Jarno | GPG: 1024D/F1BCDB73 : :' : Debian developer | Electrical Engineer `. `' [email protected] | [email protected] `- people.debian.org/~aurel32 | www.aurel32.net _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
Hi Aurelien,
Quoted 6 lines · Aurelien Jarno
The simple patch below removes the error message if the die-code entry is missing in /sys. It has been removed from the 2.6 kernels for a long time.
It is still present for 2.4 kernels though, so we should keep the code reading this entry.
Patch applied, thanks.
Signature · 6 lines
Jean Delvare _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors