Skip to contentSkip to conversation

kbuild: check asm symlink when building a kernel

RFT Sam Ravnborg 1 participant 1 message Oct 17, 2007 Kbuild

lore
Share & tools
lore
#0 lore raw

We often hit the situation where the asm symlink in include/ points to the wrong architecture. In 9 out of 10 cases thats because we forgot to set ARCH but sometimes we just reused the same tree for another ARCH. For the merged x86 tree we need to create a new symlink but this is not obvious. So with the following patch we check if the symlink points to the correct architecture and error out if this is not the case.

For x86 a "rm include/asm" is enough but we recommend make mrproper for the general case.

The patch survives my testing but before pushing it to -mm or -linus I would like a few more to test it in their environment.
I am a bit unsafe with the use of readlink and cut since they are not widely used by the kernel
build today.

Any feedback good/bad appreciated!

PS - I know that the lines are too long in the patch but
breaking them would hurt readability.

Sam

Makefile +18 -8
index ed65de7..136d7c2 100644
@@ -903,14 +903,24 @@ prepare: prepare0
 
 export CPPFLAGS_vmlinux.lds += -P -C -U$(ARCH)
 
-# FIXME: The asm symlink changes when $(ARCH) changes. That's
-# hard to detect, but I suppose "make mrproper" is a good idea
-# before switching between archs anyway.
-
-include/asm:
-	@echo '  SYMLINK $@ -> include/asm-$(SRCARCH)'
-	$(Q)if [ ! -d include ]; then mkdir -p include; fi;
-	@ln -fsn asm-$(SRCARCH) $@
+# The asm symlink changes when $(ARCH) changes.
+# Detect this and ask user to run make mrproper
+
+include/asm: FORCE
+	$(Q)set -e; asmlink=`readlink include/asm | cut -d '-' -f 2`;   \
+	if [ -L include/asm ]; then                                     \
+		if [ "$$asmlink" != "$(SRCARCH)" ]; then                \
+			echo "ERROR: the symlink $@ points to asm-$$asmlink but asm-$(SRCARCH) was expected"; \
+			echo "       save .config and run 'make mrproper' to fix it";                         \
+			exit 1;                                         \
+		fi;                                                     \
+	else                                                            \
+		echo '  SYMLINK $@ -> include/asm-$(SRCARCH)';          \
+		if [ ! -d include ]; then                               \
+			mkdir -p include;                               \
+		fi;                                                     \
+		ln -fsn asm-$(SRCARCH) $@;                              \
+	fi
 
 # Generate some files
 # ---------------------------------------------------------------------------