Skip to contentSkip to conversation

2.6.23-git12: WARNING: at fs/sysfs/dir.c:424 sysfs_add_one()

DISCUSSION Mark Lord 3 participants 4 messages Oct 18, 2007 – Oct 24, 2007

lore
Share & tools
lore

Mark Lord

author
#0 lore raw

usb 5-1: new high speed USB device using ehci_hcd and address 2 usb 5-1: configuration #1 chosen from 1 choice
hub 5-1:1.0: USB hub found
hub 5-1:1.0: 4 ports detected
sysfs: duplicate filename 'bInterfaceNumber' can not be created

WARNING: at fs/sysfs/dir.c:424 sysfs_add_one()
[sysfs_add_one+159/224] sysfs_add_one+0x9f/0xe0

hda_intel: azx_get_response timeout, switching to polling mode: last cmd=0x010f000c [sysfs_add_file+79/144] sysfs_add_file+0x4f/0x90
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX. [sysfs_create_group+103/256] sysfs_create_group+0x67/0x100 [klist_add_tail+30/80] klist_add_tail+0x1e/0x50
[device_add+61/1472] device_add+0x3d/0x5c0

[<f88a3adc>] usb_create_sysfs_intf_files+0x2c/0xb0 [usbcore]
[<f889f701>] usb_set_configuration+0x391/0x5d0 [usbcore]
[<f88a7c16>] generic_probe+0x76/0xb0 [usbcore]
[<f88a1343>] usb_probe_device+0x33/0x40 [usbcore]
[driver_probe_device+142/400] driver_probe_device+0x8e/0x190
[klist_next+93/160] klist_next+0x5d/0xa0
[bus_for_each_drv+68/112] bus_for_each_drv+0x44/0x70
[device_attach+125/144] device_attach+0x7d/0x90
[__device_attach+0/16] __device_attach+0x0/0x10
[bus_attach_device+77/160] bus_attach_device+0x4d/0xa0
[bus_add_device+300/352] bus_add_device+0x12c/0x160
[device_add+1155/1472] device_add+0x483/0x5c0
[<f889a274>] usb_new_device+0x54/0xa0 [usbcore]
[<f889ab9a>] hub_thread+0x45a/0xca0 [usbcore]
[schedule+460/1680] schedule+0x1cc/0x690
[autoremove_wake_function+0/80] autoremove_wake_function+0x0/0x50
[<f889a740>] hub_thread+0x0/0xca0 [usbcore]
[kthread+66/112] kthread+0x42/0x70
[kthread+0/112] kthread+0x0/0x70
[kernel_thread_helper+7/24] kernel_thread_helper+0x7/0x18
=======================

NET: Registered protocol family 17

#1 lore raw
Quoted 6 lines · Mark Lord

usb 5-1: new high speed USB device using ehci_hcd and address 2 usb 5-1: configuration #1 chosen from 1 choice
hub 5-1:1.0: USB hub found
hub 5-1:1.0: 4 ports detected
sysfs: duplicate filename 'bInterfaceNumber' can not be created

Known issue, people are working on it, there's already a proposed patch on lkml for this.

thanks,

greg k-h

#2 lore raw
Quoted 9 lines · Greg KH
Quoted 5 lines · Mark Lord

usb 5-1: new high speed USB device using ehci_hcd and address 2 usb 5-1: configuration #1 chosen from 1 choice
hub 5-1:1.0: USB hub found
hub 5-1:1.0: 4 ports detected
sysfs: duplicate filename 'bInterfaceNumber' can not be created

Known issue, people are working on it, there's already a proposed patch on lkml for this.

But it's not in 2.6.24-rc1, right?

With kind regards,

Geert Uytterhoeven
Software Architect

Sony Network and Software Technology Center Europe
The Corporate Village · Da Vincilaan 7-D1 · B-1935 Zaventem · Belgium

Phone:    +32 (0)2 700 8453	
Fax:      +32 (0)2 700 8622	
E-mail:   [email protected]	
Internet: http://www.sony-europe.com/

Sony Network and Software Technology Center Europe
A division of Sony Service Centre (Europe) N.V. Registered office: Technologielaan 7 · B-1840 Londerzeel · Belgium VAT BE 0413.825.160 · RPR Brussels
Fortis Bank Zaventem · Swift GEBABEBB08A · IBAN BE39001382358619

#3 lore raw
Quoted 8 lines · Geert Uytterhoeven
Quoted 7 lines · Greg KH
Quoted 5 lines · Mark Lord

usb 5-1: new high speed USB device using ehci_hcd and address 2 usb 5-1: configuration #1 chosen from 1 choice
hub 5-1:1.0: USB hub found
hub 5-1:1.0: 4 ports detected
sysfs: duplicate filename 'bInterfaceNumber' can not be created

Quoted 4 lines
Quoted 2 lines

Known issue, people are working on it, there's already a proposed patch on lkml for this.

But it's not in 2.6.24-rc1, right?

No, not yet, give me a day or so...

thanks,

greg k-h