Skip to contentSkip to conversation

doesm mdadm try to use fastest HDD ?

DISCUSSION Janek Kozicki 3 participants 3 messages Nov 2, 2007 – Nov 7, 2007 MD RAID

lore
Share & tools
lore
#0 lore raw

Hello,

My three HHDs have following speeds:

hda - speed 70 MB/sec
hdc - speed 27 MB/sec
sda - speed 60 MB/sec

They create a raid1 /dev/md0 and raid5 /dev/md1 arrays. I wanted to ask if mdadm is trying to pick the fastest HDD during operation?

Maybe I can "tell" which HDD is preferred?

This came to my mind when I saw this:

  # mdadm --query --detail /dev/md1 | grep Prefer

Preferred Minor : 1

And also in the manual:

-W, --write-mostly [...] "can be useful if mirroring over a slow link."

many thanks for all your help!

Signature · 1 line
Janek Kozicki                                                         |
#1 lore raw
Quoted 4 lines · Janek Kozicki

Hello,

My three HHDs have following speeds:

Quoted 9 lines

hda - speed 70 MB/sec
hdc - speed 27 MB/sec
sda - speed 60 MB/sec

They create a raid1 /dev/md0 and raid5 /dev/md1 arrays. I wanted to ask if mdadm is trying to pick the fastest HDD during operation?

Maybe I can "tell" which HDD is preferred?

If you are doing raid-1 between hdc and some faster drive, you could try using write-mostly and see go that works for you. For raid-5, it's faster to read the data off the slow drive than reconstruct it with multiple reads to multiple othjer faster drives.

Quoted 4 lines

This came to my mind when I saw this:

  # mdadm --query --detail /dev/md1 | grep Prefer
Quoted 9 lines

Preferred Minor : 1

And also in the manual:

-W, --write-mostly [...] "can be useful if mirroring over a slow link."

many thanks for all your help!

I have two thoughts on this:
1 - if performance is critical, replace the slow drive
2 - for most things you do, I would expect seek to be more important than transfer rate

Signature · 3 lines
bill davidsen <[email protected]>
 CTO TMR Associates, Inc
 Doing interesting things with small computers since 1979
#2 lore raw
Quoted 12 lines · Bill Davidsen
Quoted 11 lines · Janek Kozicki

Hello,

My three HHDs have following speeds:

hda - speed 70 MB/sec
hdc - speed 27 MB/sec
sda - speed 60 MB/sec

They create a raid1 /dev/md0 and raid5 /dev/md1 arrays. I wanted to ask if mdadm is trying to pick the fastest HDD during operation?

Quoted 7 lines
Quoted 2 lines

Maybe I can "tell" which HDD is preferred?

If you are doing raid-1 between hdc and some faster drive, you could try using write-mostly and see go that works for you. For raid-5, it's faster to read the data off the slow drive than reconstruct it with multiple reads to multiple othjer faster drives.

Won't it naturally balance reads according to the disk speeds if there are enough streams reading? I know raid1 prefers a disk that is already near the location it wants. But won't it pick the first idle one if there is no disk near the location? And the faster disk will be idle more often.

MfG
Goswin