Skip to contentSkip to conversation

drive side 80-wire cable detection failed

PATCH Tobias Hoffmann 2 participants 4 messages Nov 3, 2007 – Nov 5, 2007

lore
Share & tools
lore
#0 lore raw

Hi!

On my NV3 board with a Samsung SP1634N Harddisk I wrongly got "drive side 80-wire cable detection failed" with the current kernel.

A possible fix is attached.

Please CC any replies as I'm not on the list.

Tobias

drivers/ide/ide-iops.c +0 -0
index dcda0f1..e3cfd6c 100644
@@ -588,6 +588,7 @@ EXPORT_SYMBOL_GPL(ide_in_drive_list);
static const struct drive_list_entry ivb_list[] = {
       { "QUANTUM FIREBALLlct10 05"    , "A03.0900"    },
       { "TSSTcorp CDDVDW SH-S202J"    , "SB00"        },
+       { "SAMSUNG SP1634N"             , "UZ100-03"    },
       { NULL                          , NULL          }
};
#1 lore raw
Quoted 4 lines · On Sun, 04 Nov 2007 00:09:49 +0100 Tobias Hoffmann <[email protected]>…

Hi!

On my NV3 board with a Samsung SP1634N Harddisk I wrongly got "drive side 80-wire cable detection failed" with the current kernel.

Does the drive cable detect correctly on a non Nvidia chipset ?

#2 lore raw
Quoted 5 lines · Alan Cox
Quoted 2 lines

On my NV3 board with a Samsung SP1634N Harddisk I wrongly got "drive side 80-wire cable detection failed" with the current kernel.

Does the drive cable detect correctly on a non Nvidia chipset ?

I have no box here to test this - my laptop won't help.

But I did another test:

I replaced the 80-wire cable with a 40-wire cable. Then the BIOS warns about "no 80-wire cable connected". The kernel boot and seems to enable UDMA100 which leads to some BadCRC errors. After that the drive is in udma3-mode(hdparm) IIRC but not in udma5, as when using the right cable.

Maybe it's not that clever to add the drive to the ivb_list?

As far as I understood it, pata_acpi should fix the problem, but I'm not sure on the required configuration. Do I have to disable the normal IDE-support? How 'experimental' is the PATA support?

Tobias

#3 lore raw
Quoted 3 lines

As far as I understood it, pata_acpi should fix the problem, but I'm not sure on the required configuration. Do I have to disable the normal IDE-support? How 'experimental' is the PATA support?

The pata_amd (AMD/Nvidia) driver is pretty robust, but I would expect the same results from both in your case at the moment. Tejun is still fixing ACPI bits so after that it might be worth trying.

Alan