Skip to contentSkip to conversation

telling mdadm to use spare drive.

DISCUSSION Janek Kozicki 1 participant 2 messages Nov 4, 2007

lore
Share & tools
lore
#0 lore raw

Hi,

I finished copying all data from old disc hdc to my shiny new RAID5 array (/dev/hda3 /dev/sda3 missing). Next step is to create a partition on hdc and add it to the array. And so I did this:

# mdadm --add /dev/md1 /dev/hdc3

But then I had a problem - the /dev/hdc3 was a spare, it didn't resync automatically:

# mdadm -D /dev/md1
[....]
    Number   Major   Minor   RaidDevice State
       0       3        3        0      active sync   /dev/hda3
       1       8        3        1      active sync   /dev/sda3
       2       0        0        2      removed

3 22 3 - spare /dev/hdc3

I wanted to tell mdadm to use the spare device, and I wasn't sure how to do this, so I tried following:

# mdadm --stop /dev/md1
# mdadm --assemble --update=resync /dev/md1 /dev/hda3 /dev/sda3 /dev/hdc3

Now, 'mdadm -D /dev/md1' says:
[...]
Number Major Minor RaidDevice State
0 3 3 0 active sync /dev/hda3
1 8 3 1 active sync /dev/sda3
3 22 3 2 spare rebuilding /dev/hdc3

I'm writing here just because I want to be sure that I added this new device correctly, I don't want to make any stupid mistake here...

# cat /proc/mdstat

md1 : active raid5 hda3[0] hdc3[3] sda3[1]

      966807296 blocks super 1.1 level 5, 128k chunk, algorithm 2 [3/2] [UU_]
      [=>...................]  recovery =  6.2% (30068096/483403648) finish=254.9min speed=29639K/sec
      bitmap: 8/8 pages [32KB], 32768KB chunk

Was there a better way to do this, is it OK?

Signature · 1 line
Janek Kozicki                                                         |
#1 lore raw

Re: telling mdadm to use spare drive, [OT]

oops. I'm really sorry I wanted to send this to linux-raid.

Signature · 1 line
Janek Kozicki                                                         |