Skip to contentSkip to conversation

NFS over bridged interface

Bridge Vivek Shrivastava 2 participants 2 messages Nov 14, 2007 Ethernet bridge

lore
Share & tools
lore
#0 lore raw

Hi,
I am running NFS over my soekris boxes, with eth0 as the primary
wired interface (that gets dhcp ip address from the server and loads the entire NFS filesystem). Now I want to bridge traffic from (some traffic) eth0 to eth1 (another interface). But as soon as I add eth0 to the bridge, the box stops responding. I have waited more than 30 sec (the default bridging fwd delay), but still see no response. I am a new to this community so I am not sure if this has been already discussed. Any help will be greatly appreciated.

Thanks
Vivek

#1 lore raw
Quoted 10 lines · On Wed, 14 Nov 2007 09:45:17 -0600 Vivek Shrivastava <[email protected]> wrote:

Hi,
I am running NFS over my soekris boxes, with eth0 as the primary
wired interface (that gets dhcp ip address from the server and loads the entire NFS filesystem). Now I want to bridge traffic from (some traffic) eth0 to eth1 (another interface). But as soon as I add eth0 to the bridge, the box stops responding. I have waited more than 30 sec (the default bridging fwd delay), but still see no response. I am a new to this community so I am not sure if this has been already discussed. Any help will be greatly appreciated.

Quoted 2 lines

Thanks
Vivek

You need to use dhcp on the bridge interface.

# brctl addbr br0
# ifconfig eth0 0.0.0.0    # mark up with no address
# ifconfig eth1 0.0.0.0
# brctl setfd br0 0        # turn off forwarding delay
# brctl addif br0 eth0 eth1
# dhclient br0
Signature · 1 line
Stephen Hemminger <[email protected]>