Skip to contentSkip to conversation

IB/ehca: Return correct #SGEs for SRQ

PATCH Applied Joachim Fenkes 2 participants 2 messages Dec 10, 2007 – Dec 12, 2007 InfiniBand

lore
Share & tools
lore

Joachim Fenkes

author
#0 lore raw

PATCH 1/1 IB/ehca: Return correct #SGEs for SRQ

Firmware would round up the number of SGEs to four, because the WQE structure holds four SGEs. For SRQ, only three are supported, so return a fixed value instead.

Signed-off-by Joachim Fenkes <[email protected]>

---

The patch will apply cleanly on top of Roland's git. Please review and apply for 2.6.24 -- Thanks!

 drivers/infiniband/hw/ehca/ehca_qp.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)
drivers/infiniband/hw/ehca/ehca_qp.c +2 -2
index dd12668..eff5fb5 100644
@@ -838,7 +838,7 @@ struct ib_srq *ehca_create_srq(struct ib_pd *pd,
 
 	/* copy back return values */
 	srq_init_attr->attr.max_wr = qp_init_attr.cap.max_recv_wr;
-	srq_init_attr->attr.max_sge = qp_init_attr.cap.max_recv_sge;
+	srq_init_attr->attr.max_sge = 3;
 
 	/* drive SRQ into RTR state */
 	mqpcb = ehca_alloc_fw_ctrlblock(GFP_KERNEL);

@@ -1750,7 +1750,7 @@ int ehca_query_srq(struct ib_srq *srq, struct ib_srq_attr *srq_attr)
 	}
 
 	srq_attr->max_wr = qpcb->max_nr_outst_recv_wr - 1;
-	srq_attr->max_sge = qpcb->actual_nr_sges_in_rq_wqe;
+	srq_attr->max_sge = 3;
 	srq_attr->srq_limit = EHCA_BMASK_GET(
 		MQPCB_CURR_SRQ_LIMIT, qpcb->curr_srq_limit);
Signature · 1 line
1.5.2