New: cpufreq reports too low max freq on Intel P4
http://bugzilla.kernel.org/show_bug.cgi?id=9636
Summary: cpufreq reports too low max freq on Intel P4
Product: Power Management
Version: 2.5
KernelVersion: 2.6.23
Platform: All
OS/Version: Linux
Tree: Mainline
Status: NEW
Severity: high
Priority: P1
Component: cpufreq
AssignedTo: [email protected]
ReportedBy: [email protected]
Most recent kernel where this bug did not occur: -
Distribution: Debian testing
Hardware Environment: Intel P4 3.0GHz HT, Intel 945 chipset Software Environment: Debian testing
Problem Description:
Using the acpi-cpufreq driver the CPU will not switch to a frequency higher than 1.5 GHz; the sysfs cpufreq interface (cpuinfo_max_freq) reports 1.5 GHz to be the maximum frequency available as well.
The same kernel without cpufreq support enabled does not show those problems, the CPU will run at 3 GHz without cpufreq.
Kernel 2.6.23 and 2.6.24-rc* both show the problem.
Here some output with cpufreq enabled:
# cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_max_freq 1500000 # cat /sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_max_freq 1500000 # cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_available_frequencies 1500000 1400000
Actually it *should* report frequencies up to 3 GHz, but only does report up to 1.5 GHz.
I'm gonna attach the /proc/cpuinfo data to this bug report, let me know if you need any other information.
This is a really, really nasty bug.
Steps to reproduce: Depends on my hardware I guess.
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
http://bugzilla.kernel.org/show_bug.cgi?id=9636
------- Comment #1 from [email protected] 2007-12-26 04:35 ------- Created an attachment (id=14189)
--> (http://bugzilla.kernel.org/attachment.cgi?id=14189&action=view)/proc/cpuinfo of the affected machine.
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
In reply to [email protected]http://bugzilla.kernel.org/show_bug.cgi?id=9636
------- Comment #2 from [email protected] 2007-12-26 04:39 -------
BTW: I'm using the ondemand-governor and acpi-cpufreq as driver:
# cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_driver acpi-cpufreq # cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor ondemand
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
In reply to [email protected]http://bugzilla.kernel.org/show_bug.cgi?id=9636
------- Comment #3 from [email protected] 2008-01-01 10:15 ------- First, look out for a BIOS update.
If this does not help, do you see any acpi warnings/errors in dmesg:
dmesg |grep -i acpi
If the BIOS update does not help, pls attach apcidump output.
This sounds like wrongly exported BIOS values for this CPU, which often get fixed up by BIOS upgrades or possibly an ACPI interpreter bug.
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
In reply to [email protected]http://bugzilla.kernel.org/show_bug.cgi?id=9636
------- Comment #4 from [email protected] 2008-01-27 03:20 ------- Latest BIOS update done, didn't help at all.
BTW the machine is an IBM ThinkCentre 9210-CTO.
$ dmesg |grep -i acpi BIOS-e820: 000000003f520000 - 000000003f536000 (ACPI data) BIOS-e820: 000000003f536000 - 000000003f600000 (ACPI NVS) ACPI: RSDP 000F6590, 0014 (r0 PTLTD ) ACPI: RSDT 3F53003F, 0040 (r1 PTLTD RSDT 60400D0 LTP 0) ACPI: FACP 3F535E2B, 0074 (r1 IBM THINKCEN 60400D0 PTL 1) ACPI: DSDT 3F530761, 56CA (r1 IBM THINKCEN 60400D0 MSFT 100000E) ACPI: FACS 3F58BFC0, 0040 ACPI: TCPA 3F535E9F, 0032 (r2 IBM THINKCEN 60400D0 PTL 1) ACPI: MCFG 3F535ED1, 003C (r1 PTLTD MCFG 60400D0 LTP 0) ACPI: APIC 3F535F0D, 0068 (r1 PTLTD APIC 60400D0 LTP 0) ACPI: BOOT 3F535F75, 0028 (r1 PTLTD $SBFTBL$ 60400D0 LTP 1) ACPI: ASF! 3F535F9D, 0063 (r32 CETP CETP 60400D0 PTL 1) ACPI: SSDT 3F53007F, 01FB (r1 PmRef CpuPm 3000 INTL 20030224) ACPI: PM-Timer IO Port: 0x1008 ACPI: Local APIC address 0xfee00000 ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled) ACPI: LAPIC (acpi_id[0x01] lapic_id[0x01] enabled) ACPI: LAPIC_NMI (acpi_id[0x00] high edge lint[0x1]) ACPI: LAPIC_NMI (acpi_id[0x01] high edge lint[0x1]) ACPI: IOAPIC (id[0x02] address[0xfec00000] gsi_base[0]) ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 high edge) ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level) ACPI: IRQ0 used by override. ACPI: IRQ2 used by override. ACPI: IRQ9 used by override. Using ACPI (MADT) for SMP configuration information ACPI: Core revision 20070126 ACPI: bus type pci registered ACPI: EC: Look up EC in DSDT ACPI: Interpreter enabled ACPI: (supports S0 S5) ACPI: Using IOAPIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (0000:00) PCI quirk: region 1000-107f claimed by ICH6 ACPI/GPIO/TCO ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.EXP0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.EXP1._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.SLOT._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 *7 9 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 *5 7 9 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 7 9 *10 11 12 14 15) ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 7 *9 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 7 9 10 11 12 14 15) *0, disabled. ACPI: PCI Interrupt Link [LNKF] (IRQs *3 4 5 7 9 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKG] (IRQs 3 4 5 7 9 10 11 12 14 15) *0, disabled. ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 7 9 10 *11 12 14 15) pnp: PnP ACPI init ACPI: bus type pnp registered pnp: PnP ACPI: found 14 devices ACPI: ACPI bus type pnp unregistered PCI: Using ACPI for IRQ routing ACPI: RTC can wake from S4 ACPI: PCI Interrupt 0000:00:1c.0[A] -> GSI 17 (level, low) -> IRQ 16 ACPI: PCI Interrupt 0000:00:1c.1[B] -> GSI 16 (level, low) -> IRQ 17 ACPI: Power Button (FF) [PWRF] ACPI: Power Button (CM) [PWRB] ACPI: SSDT 3F53030A, 01C3 (r1 PmRef Cpu0Ist 3000 INTL 20030224) ACPI: Processor [CPU0] (supports 8 throttling states) ACPI: SSDT 3F53027A, 0090 (r1 PmRef Cpu1Ist 3000 INTL 20030224) ACPI: Processor [CPU1] (supports 8 throttling states) ACPI: Thermal Zone [THM0] (60 C) ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 17 ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 17 ACPI: PCI Interrupt 0000:00:1f.2[B] -> GSI 19 (level, low) -> IRQ 18 ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 23 (level, low) -> IRQ 19 ACPI: PCI Interrupt 0000:00:1d.1[B] -> GSI 19 (level, low) -> IRQ 18 ACPI: PCI Interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 20 ACPI: PCI Interrupt 0000:00:1d.3[D] -> GSI 16 (level, low) -> IRQ 17 ACPI: PCI Interrupt 0000:00:1f.3[B] -> GSI 19 (level, low) -> IRQ 18
acpidump output attached. Sorry for the little delay but I didn't have physical access to the machine to do the BIOS upgrade for the last 2 weeks. Thanks for investigating this :)
Peter
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
In reply to [email protected]http://bugzilla.kernel.org/show_bug.cgi?id=9636
------- Comment #5 from [email protected] 2008-01-27 03:21 ------- Created an attachment (id=14595)
--> (http://bugzilla.kernel.org/attachment.cgi?id=14595&action=view)
acpidump output.
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.
[Bug 9636] cpufreq reports too low max freq on Intel P4
In reply to [email protected]http://bugzilla.kernel.org/show_bug.cgi?id=9636
[email protected] changed:
What |Removed |Added
----------------------------------------------------------------------------
CC| |[email protected]
Signature · 3 lines
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug, or are watching the assignee.