Skip to contentSkip to conversation

Help debugging filesystem activity?

DISCUSSION rzryyvzy 2 participants 3 messages Feb 11, 2008

lore
Share & tools
lore

rzryyvzy

author
#0 lore raw

My hard disk on my server is all the time readding and writing some files (I can see it with dstat). However I would like to know which files exactly are readden or written all the time. I know that each filesystem activity goes by the VFS (virtual filesystem). Is it possible to see all current open files in the VFS?
For example with a command like:

$ cat /proc/fs/vfs/open_files
$ cat /proc/fs/vfs/reading_files
$ cat /proc/fs/vfs/writing_files

?
Is there a possibility? It should be on the VFS level to be independent of the used filesystem.

Signature · 5 lines
Best regards

-- 
E-Mail sent with anti-spam site TrashMail.net!
Free disposable email addresses: http://www.trashmail.net/
#1 lore raw
Quoted 3 lines · rzryyvzy
$ cat /proc/fs/vfs/reading_files
$ cat /proc/fs/vfs/writing_files

You can try:

# echo 1 > /proc/sys/vm/block_dump
# dmesg

HTH.

Signature · 1 line
Guillaume
author
#2 lore raw
Quoted 4 lines · Guillaume Chazarain
Quoted 2 lines · rzryyvzy
$ cat /proc/fs/vfs/reading_files
Quoted 8 lines
Quoted 2 lines
$ cat /proc/fs/vfs/writing_files

You can try:

# echo 1 > /proc/sys/vm/block_dump
# dmesg

Thanks, it works. This option rocks. I did not know about that. This is what I really like in Linux: Everything is possible.

Signature · 2 lines
Best regards,
Mika Lawando