Skip to contentSkip to conversation

Use menuconfig for CONFIG_SPI

PATCH In review Alessandro Guido 2 participants 2 messages Feb 13, 2008 1 message not in the archive SPI

lore
Share & tools
lore

Alessandro Guido

author
#0 lore raw

PATCH 1/1 Use menuconfig for CONFIG_SPI

Signed-off-by Alessandro Guido <[email protected]>

---

 drivers/spi/Kconfig |   13 ++++++-------
 1 files changed, 6 insertions(+), 7 deletions(-)
drivers/spi/Kconfig +6 -7
index d810789..fae9e8f 100644
@@ -5,11 +5,9 @@
 # nobody's needed a slave side API yet.  The master-role API is not
 # fully appropriate there, so it'd need some thought to do well.
 #
-menu "SPI support"
-	depends on HAS_IOMEM
-
-config SPI
+menuconfig SPI
 	bool "SPI support"
+	depends on HAS_IOMEM
 	help
 	  The "Serial Peripheral Interface" is a low level synchronous
 	  protocol.  Chips that support SPI can have data transfer rates

@@ -28,9 +26,11 @@ config SPI
 	  (half duplex), SSP, SSI, and PSP.  This driver framework should
 	  work with most such devices and controllers.
 
+if SPI
+
 config SPI_DEBUG
 	boolean "Debug support for SPI drivers"
-	depends on SPI && DEBUG_KERNEL
+	depends on DEBUG_KERNEL
 	help
 	  Say "yes" to enable debug messaging (like dev_dbg and pr_debug),
 	  sysfs, and debugfs support in SPI controller and protocol drivers.

@@ -245,5 +245,4 @@ config SPI_TLE62X0
 
 # (slave support would go here)
 
-endmenu # "SPI support"
-
+endif # SPI

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

A message that is not in the archive (sent off-list or not yet received): 200802132328.01729.alessandro.guido-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org

#2 lore raw

From: Alessandro Guido <[email protected]>
Subject: [PATCH] Use menuconfig for CONFIG_SPI

Signed-off-by Alessandro Guido <[email protected]>
Signed-off-by David Brownell <[email protected]>
---
 drivers/spi/Kconfig |   13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)
drivers/spi/Kconfig +6 -7
@@ -5,11 +5,9 @@
 # nobody's needed a slave side API yet.  The master-role API is not
 # fully appropriate there, so it'd need some thought to do well.
 #
-menu "SPI support"
-	depends on HAS_IOMEM
-
-config SPI
+menuconfig SPI
 	bool "SPI support"
+	depends on HAS_IOMEM
 	help
 	  The "Serial Peripheral Interface" is a low level synchronous
 	  protocol.  Chips that support SPI can have data transfer rates

@@ -28,9 +26,11 @@ config SPI
 	  (half duplex), SSP, SSI, and PSP.  This driver framework should
 	  work with most such devices and controllers.
 
+if SPI
+
 config SPI_DEBUG
 	boolean "Debug support for SPI drivers"
-	depends on SPI && DEBUG_KERNEL
+	depends on DEBUG_KERNEL
 	help
 	  Say "yes" to enable debug messaging (like dev_dbg and pr_debug),
 	  sysfs, and debugfs support in SPI controller and protocol drivers.

@@ -252,5 +252,4 @@ config SPI_TLE62X0
 
 # (slave support would go here)
 
-endmenu # "SPI support"
-
+endif # SPI

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/