Skip to contentSkip to conversation

igb: fix legacy mode irq issue

PATCH Applied Auke Kok 2 participants 2 messages Feb 15, 2008 – Feb 20, 2008

Subsystems (2)
lore
Share & tools
lore

Auke Kok

author
#0 lore raw

PATCH 1/1 igb: fix legacy mode irq issue

From: Andy Gospodarek <[email protected]>

I booted an igb kernel with the option pci=nomsi and instantly noticed that interrupts no longer worked on my igb device. I took a look at the interrupt initialization and quickly discovered a comment stating:

"DO NOT USE EIAME or IAME in legacy mode"

It seemed a bit odd that bits to enable IAM were being set in legacy interrupt mode, so I dropped out the following parts and interrupts began working fine again.

[Updated code flow and a nitpick spelling error --Auke]

---

 drivers/net/igb/igb_main.c |    9 ++-------
 1 files changed, 2 insertions(+), 7 deletions(-)
drivers/net/igb/igb_main.c +2 -7
index bff280e..3480cc7 100644
@@ -439,7 +439,7 @@ static int igb_request_irq(struct igb_adapter *adapter)
 		err = igb_request_msix(adapter);
 		if (!err) {
 			/* enable IAM, auto-mask,
-			 * DO NOT USE EIAME or IAME in legacy mode */
+			 * DO NOT USE EIAM or IAM in legacy mode */
 			wr32(E1000_IAM, IMS_ENABLE_MASK);
 			goto request_done;
 		}
@@ -465,14 +465,9 @@ static int igb_request_irq(struct igb_adapter *adapter)
 	err = request_irq(adapter->pdev->irq, &igb_intr, IRQF_SHARED,
 			  netdev->name, netdev);
 
-	if (err) {
+	if (err)
 		dev_err(&adapter->pdev->dev, "Error %d getting interrupt\n",
 			err);
-		goto request_done;
-	}
-
-	/* enable IAM, auto-mask */
-	wr32(E1000_IAM, IMS_ENABLE_MASK);
 
 request_done:
 	return err;
Applied
#1 lore raw
Quoted 8 lines · Auke Kok

From: Andy Gospodarek <[email protected]>

I booted an igb kernel with the option pci=nomsi and instantly noticed that interrupts no longer worked on my igb device. I took a look at the interrupt initialization and quickly discovered a comment stating:

"DO NOT USE EIAME or IAME in legacy mode"

Quoted 8 lines

It seemed a bit odd that bits to enable IAM were being set in legacy interrupt mode, so I dropped out the following parts and interrupts began working fine again.

[Updated code flow and a nitpick spelling error --Auke]

applied

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/