Skip to contentSkip to conversation

PPC440EPx: Optionally enable second I2C bus

PATCH New Mike Nuss 2 participants 2 messages Feb 6, 2008 – Feb 16, 2008

lore
Share & tools
lore

Mike Nuss

author
#0 lore raw

PATCH 1/1 PPC440EPx: Optionally enable second I2C bus

The option CONFIG_I2C_MULTI_BUS does not have any effect on Sequoia, the PPC440EPx reference platform, because IIC1 is never enabled. Add Sequoia board code to turn on IIC1 if CONFIG_I2C_MULTI_BUS is selected.

Cc Stefan Roese <[email protected]>
board/amcc/sequoia/sequoia.c +4 -1
index 57905de..6bcb3ab 100644
@@ -86,10 +86,13 @@ int board_early_init_f(void)
 	/* enable USB device */
 	out_8((u8 *) CFG_BCSR_BASE + 0x09, 0x20);
 
-	/* select Ethernet pins */
+	/* select Ethernet (and optionally IIC1) pins */
 	mfsdr(SDR0_PFC1, sdr0_pfc1);
 	sdr0_pfc1 = (sdr0_pfc1 & ~SDR0_PFC1_SELECT_MASK) |
 		SDR0_PFC1_SELECT_CONFIG_4;
+#ifdef CONFIG_I2C_MULTI_BUS
+	sdr0_pfc1 |= ((sdr0_pfc1 & ~SDR0_PFC1_SIS_MASK) | SDR0_PFC1_SIS_IIC1_SEL);
+#endif
 	mfsdr(SDR0_PFC2, sdr0_pfc2);
 	sdr0_pfc2 = (sdr0_pfc2 & ~SDR0_PFC2_SELECT_MASK) |
 		SDR0_PFC2_SELECT_CONFIG_4;
Applied
#1 lore raw

PATCH 1/1 PPC440EPx: Optionally enable second I2C bus

Quoted 6 lines · Mike Nuss

The option CONFIG_I2C_MULTI_BUS does not have any effect on Sequoia, the PPC440EPx reference platform, because IIC1 is never enabled. Add Sequoia board code to turn on IIC1 if CONFIG_I2C_MULTI_BUS is selected.

Cc Stefan Roese <[email protected]>

Applied. Thanks.

Best regards,
Stefan

=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================