stack trace immediately before rebooting/switching off
In 2.6.25 I get stack trace immediately before system is switched off or reboots. It is too fast to capture it on VGA; netconsole does not capture it either - probably network is already shutdown at this point. I do not have serial port on this system.
Any idea how could I capture it? Thank you.
The problem did not exist in 2.6.24 and below.
-andrey
Quoted 8 lines · Andrey Borzenkov
In 2.6.25 I get stack trace immediately before system is switched off or reboots. It is too fast to capture it on VGA; netconsole does not capture it either - probably network is already shutdown at this point. I do not have serial port on this system.
Any idea how could I capture it? Thank you.
The problem did not exist in 2.6.24 and below.
Is this the e100 issue you reported later or something else?
Rafael
Quoted 6 lines · Rafael J. Wysocki
Quoted 5 lines · Andrey Borzenkov
In 2.6.25 I get stack trace immediately before system is switched off or reboots. It is too fast to capture it on VGA; netconsole does not capture it either - probably network is already shutdown at this point. I do not have serial port on this system.
Quoted 6 lines
Quoted 3 lines
Any idea how could I capture it? Thank you.
The problem did not exist in 2.6.24 and below.
Is this the e100 issue you reported later or something else?
Well, I can't be entirely sure unless I have some way to capture this :)
Quoted 9 lines · On Sun, 17 Feb 2008 15:16:53 +0300 Andrey Borzenkov <[email protected]> wrote:
In 2.6.25 I get stack trace immediately before system is switched off or reboots. It is too fast to capture it on VGA; netconsole does not capture it either - probably network is already shutdown at this point. I do not have serial port on this system.
Any idea how could I capture it? Thank you.
The problem did not exist in 2.6.24 and below.
- put an mdelay(100000) into sys_reboot() somewhere, take photo of screen
- try plain old /sbin/halt, see if that does it as well.