Skip to contentSkip to conversation

processor flags

DISCUSSION Cyrill Gorcunov 2 participants 3 messages Mar 27, 2008

lore
Share & tools
lore
#0 lore raw

Hi Peter, Ingo

could you spend a few minutes on me? ;)

You know, I'm almost complete changing the vm86 flags with X86_EFLAGS_... but there is a hidden problem lays. Look, in vm86.h we have the definition

#ifdef CONFIG_VM86
#define VM_MASK 0x00020000
#else
#define VM_MASK 0 /* ignored */
#endif

which has an indirect conditional compilation effect. For example, if we take a look on include/asm-x86/ptrace.h

	static inline int v8086_mode(struct pt_regs *regs)
	{
	#ifdef CONFIG_X86_32
		return (regs->flags & VM_MASK);
	#else
		return 0;	/* No V86 mode support in long mode */
	#endif
	}

so if we don't have CONFIG_VM86 defined this function *always* returning 0 so there I can't just change VM_MASK to X86_EFLAGS_VM.

Another piece of code from traps_32.c:do_general_protection

	if (regs->flags & VM_MASK)
		goto gp_in_vm86;

so if we didn't set CONFIG_VM86 i think this part is just thrown out by gcc. So as we see, this VM_MASK original flag is not *just* a flag but also says gcc which part of code to compile.

And now I'm in confusion - the way of changing this code I see is the following:

- or use additional #ifdef CONFIG_VM86 in code where VM_MASK is used (that would be ugly IMHO)
- rename VM_MASK to say X86_EFLAGS_VM86 with that #ifdef remained
- rest VM_MASK as it is

How do you think?

- Cyrill -

#1 lore raw
Quoted 11 lines · Cyrill Gorcunov

And now I'm in confusion - the way of changing this code I see is the following:

- or use additional #ifdef CONFIG_VM86 in code where VM_MASK is used (that would be ugly IMHO)
- rename VM_MASK to say X86_EFLAGS_VM86 with that #ifdef remained
- rest VM_MASK as it is

How do you think?

I think what we should do is:

- Rename VM_MASK to X86_VM_MASK (it's x86-specific after all)
- Have:

#if CONFIG_VM86

# define X86_VM_MASK X86_EFLAGS_VM
#else
# define X86_VM_MASK 0		/* No V86 support */
#endif

-hpa

#2 lore raw

[H. Peter Anvin - Thu, Mar 27, 2008 at 12:55:42PM -0700]

Quoted 14 lines
Quoted 7 lines · Cyrill Gorcunov

And now I'm in confusion - the way of changing this code I see is the following:
- or use additional #ifdef CONFIG_VM86 in code where VM_MASK is used (that would be ugly IMHO)
- rename VM_MASK to say X86_EFLAGS_VM86 with that #ifdef remained
- rest VM_MASK as it is
How do you think?

I think what we should do is:

- Rename VM_MASK to X86_VM_MASK (it's x86-specific after all)
- Have:

Quoted 8 lines

#if CONFIG_VM86

# define X86_VM_MASK X86_EFLAGS_VM
#else
# define X86_VM_MASK 0		/* No V86 support */
#endif

-hpa

Thanks a lot, Peter

- Cyrill -