plat_nand: set mtd->name

This patch sets mtd->name to the platform bus ID in the plat_nand driver, so that you can specify partitions readily with mtdparts=.

Currently it relies on nand_base filling in the name from the device, which results in names like "NAND 256MiB 3,3V 8-bit", that you can't use with cmdlineparts.

--
BTW, most of the NAND drivers appear to use a fixed name, which makes it hard to use them with mtdparts= if you had multiple devices.

@@ -54,6 +54,7 @@
 	data->chip.priv = &data;
 	data->mtd.priv = &data->chip;
 	data->mtd.owner = THIS_MODULE;
+	data->mtd.name = pdev->dev.bus_id;
 
 	data->chip.IO_ADDR_R = data->io_base;
 	data->chip.IO_ADDR_W = data->io_base;

Hamish Moffatt VK3SB <[email protected]> <[email protected]>