Allow use of ARCH=powerpc when building
PATCH 1/1 Allow use of ARCH=powerpc when building
The linux kernel is now mostly ARCH=powerpc, so to make life easier allow use to use ARCH=powerpc and convert it to ARCH=ppc.
Signed-off-by Kumar Gala <[email protected]>
---
Identical to the patch 'Allow use to use ARCH=powerpc when building', but this one the subject makes a bit more sense.
Makefile | 4 ++++ 1 files changed, 4 insertions(+), 0 deletions(-)
Makefile +4 -0
@@ -123,6 +123,10 @@ unexport CDPATH ######################################################################### +ifeq ($(ARCH),powerpc) +ARCH = ppc +endif + ifeq ($(obj)include/config.mk,$(wildcard $(obj)include/config.mk)) # load ARCH, BOARD, and CPU configuration
Signature · 1 line
1.5.4.1
Wolfgang Denk
AppliedPATCH 1/1 Allow use of ARCH=powerpc when building
Quoted 8 lines · In message <[email protected]> you wrote:
The linux kernel is now mostly ARCH=powerpc, so to make life easier allow use to use ARCH=powerpc and convert it to ARCH=ppc.
Signed-off-by Kumar Gala <[email protected]>---
Identical to the patch 'Allow use to use ARCH=powerpc when building', but this one the subject makes a bit more sense.
Applied, thanks.
Best regards,
Wolfgang Denk
Signature · 5 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "What the scientists have in their briefcases is terrifying." - Nikita Khrushchev