Debug u-boot with SAM-ICE/J-link

I would like to know what is the quickest way to set up Atmel's SAM-ICE with the
AT91SAM9260EK board to run GDB? My preference is to run under a linux host,
but I can run under Windows if that is easier to setup.

Any ideas, suggestions or experiences.

Thanks,
Norman

Normaly you have an Manuel on the Atmel Web site explainig it.

But you need a Windows Host to run the JLInk gdb server but after you can connect to it with a linux station

I you really need to run everything over Linux I recommand to use a BDI2000/BDI3000 or Ronetix

Best Regards,
J.