b43: Add panic reason code that doesn't trigger restart

Index: wireless-testing/drivers/net/wireless/b43/b43.h
===================================================================
@@ -419,18 +419,27 @@ enum {
 					 B43_IRQ_TXFIFO_FLUSH_OK | \
 					 B43_IRQ_NOISESAMPLE_OK | \
 					 B43_IRQ_UCODE_DEBUG | \
 					 B43_IRQ_RFKILL | \
 					 B43_IRQ_TX_OK)
 
+/* The firmware register to fetch the debug-IRQ reason from. */
+#define B43_DEBUGIRQ_REASON_REG		63
 /* Debug-IRQ reasons. */
 #define B43_DEBUGIRQ_PANIC		0	/* The firmware panic'ed */
 #define B43_DEBUGIRQ_DUMP_SHM		1	/* Dump shared SHM */
 #define B43_DEBUGIRQ_DUMP_REGS		2	/* Dump the microcode registers */
 #define B43_DEBUGIRQ_ACK		0xFFFF	/* The host writes that to ACK the IRQ */
 
+/* The firmware register to fetch the panic reason from. */
+#define B43_FWPANIC_REASON_REG		3
+/* Firmware panic reason codes */
+#define B43_FWPANIC_DIE			0 /* Firmware died. Don't auto-restart it. */
+#define B43_FWPANIC_RESTART		1 /* Firmware died. Schedule a controller reset. */
+
+
 /* Device specific rate values.
  * The actual values defined here are (rate_in_mbps * 2).
  * Some code depends on this. Don't change it. */
 #define B43_CCK_RATE_1MB		0x02
 #define B43_CCK_RATE_2MB		0x04
 #define B43_CCK_RATE_5MB		0x0B

Index: wireless-testing/drivers/net/wireless/b43/main.c
===================================================================
@@ -1661,31 +1661,52 @@ static void b43_set_beacon_int(struct b4
 		b43_write16(dev, 0x610, beacon_int);
 	}
 	b43_time_unlock(dev);
 	b43dbg(dev->wl, "Set beacon interval to %u\n", beacon_int);
 }
 
+static void b43_handle_firmware_panic(struct b43_wldev *dev)
+{
+	u16 reason;
+
+	/* Read the register that contains the reason code for the panic. */
+	reason = b43_shm_read16(dev, B43_SHM_SCRATCH, B43_FWPANIC_REASON_REG);
+	b43err(dev->wl, "Whoopsy, firmware panic! Reason: %u\n", reason);
+
+	switch (reason) {
+	default:
+		b43dbg(dev->wl, "The panic reason is unknown.\n");
+		/* fallthrough */
+	case B43_FWPANIC_DIE:
+		/* Do not restart the controller or firmware.
+		 * The device is nonfunctional from now on.
+		 * Restarting would result in this panic to trigger again,
+		 * so we avoid that recursion. */
+		break;
+	case B43_FWPANIC_RESTART:
+		b43_controller_restart(dev, "Microcode panic");
+		break;
+	}
+}
+
 static void handle_irq_ucode_debug(struct b43_wldev *dev)
 {
 	unsigned int i, cnt;
 	u16 reason;
 	__le16 *buf;
 
 	/* The proprietary firmware doesn't have this IRQ. */
 	if (!dev->fw.opensource)
 		return;
 
-	/* Microcode register 63 contains the debug-IRQ reason. */
-	reason = b43_shm_read16(dev, B43_SHM_SCRATCH, 63);
+	/* Read the register that contains the reason code for this IRQ. */
+	reason = b43_shm_read16(dev, B43_SHM_SCRATCH, B43_DEBUGIRQ_REASON_REG);
+
 	switch (reason) {
 	case B43_DEBUGIRQ_PANIC:
-		/* The reason for the panic is in register 3. */
-		reason = b43_shm_read16(dev, B43_SHM_SCRATCH, 3);
-		b43err(dev->wl, "Whoopsy, the microcode panic'ed! Reason: %u\n",
-		       reason);
-		b43_controller_restart(dev, "Microcode panic");
+		b43_handle_firmware_panic(dev);
 		break;
 	case B43_DEBUGIRQ_DUMP_SHM:
 		if (!B43_DEBUG)
 			break; /* Only with driver debugging enabled. */
 		buf = kmalloc(4096, GFP_ATOMIC);
 		if (!buf) {

@@ -1720,13 +1741,15 @@ static void handle_irq_ucode_debug(struc
 		break;
 	default:
 		b43dbg(dev->wl, "Debug-IRQ triggered for unknown reason: %u\n",
 		       reason);
 	}
 out:
-	b43_shm_write16(dev, B43_SHM_SCRATCH, 63, B43_DEBUGIRQ_ACK);
+	/* Acknowledge the debug-IRQ, so the firmware can continue. */
+	b43_shm_write16(dev, B43_SHM_SCRATCH,
+			B43_DEBUGIRQ_REASON_REG, B43_DEBUGIRQ_ACK);
 }
 
 /* Interrupt handler bottom-half */
 static void b43_interrupt_tasklet(struct b43_wldev *dev)
 {
 	u32 reason;