ide: remove dead Virtual DMA support

Index: b/drivers/ide/ide-disk.c
===================================================================
@@ -158,7 +158,7 @@ static void ide_tf_set_cmd(ide_drive_t *
 	write = (task->tf_flags & IDE_TFLAG_WRITE) ? 1 : 0;
 
 	if (dma)
-		index = drive->vdma ? 4 : 8;
+		index = 8;
 	else
 		index = drive->mult_count ? 0 : 4;
 

Index: b/drivers/ide/ide-dma.c
===================================================================
@@ -756,9 +756,8 @@ static int ide_tune_dma(ide_drive_t *dri
 static int ide_dma_check(ide_drive_t *drive)
 {
 	ide_hwif_t *hwif = drive->hwif;
-	int vdma = (hwif->host_flags & IDE_HFLAG_VDMA)? 1 : 0;
 
-	if (!vdma && ide_tune_dma(drive))
+	if (ide_tune_dma(drive))
 		return 0;
 
 	/* TODO: always do PIO fallback */

@@ -767,7 +766,7 @@ static int ide_dma_check(ide_drive_t *dr
 
 	ide_set_max_pio(drive);
 
-	return vdma ? 0 : -1;
+	return -1;
 }
 
 int ide_id_dma_bug(ide_drive_t *drive)

Index: b/drivers/ide/ide-iops.c
===================================================================
@@ -866,8 +866,7 @@ int ide_config_drive_speed(ide_drive_t *
 
  skip:
 #ifdef CONFIG_BLK_DEV_IDEDMA
-	if ((speed >= XFER_SW_DMA_0 || (hwif->host_flags & IDE_HFLAG_VDMA)) &&
-	    drive->using_dma)
+	if (speed >= XFER_SW_DMA_0 && drive->using_dma)
 		hwif->dma_ops->dma_host_set(drive, 1);
 	else if (hwif->dma_ops)	/* check if host supports DMA */
 		ide_dma_off_quietly(drive);

Index: b/drivers/ide/pci/cs5520.c
===================================================================
@@ -62,8 +62,6 @@ static void cs5520_set_pio_mode(ide_driv
 	struct pci_dev *pdev = to_pci_dev(hwif->dev);
 	int controller = drive->dn > 1 ? 1 : 0;
 
-	/* FIXME: if DMA = 1 do we need to set the DMA bit here ? */
-
 	/* 8bit CAT/CRT - 8bit command timing for channel */
 	pci_write_config_byte(pdev, 0x62 + controller, 
 		(cs5520_pio_clocks[pio].recovery << 4) |

@@ -89,45 +87,17 @@ static void cs5520_set_dma_mode(ide_driv
 	cs5520_set_pio_mode(drive, 0);
 }
 
-/*
- *	We wrap the DMA activate to set the vdma flag. This is needed
- *	so that the IDE DMA layer issues PIO not DMA commands over the
- *	DMA channel
- *
- *	ATAPI is harder so disable it for now using IDE_HFLAG_NO_ATAPI_DMA
- */
-
-static void cs5520_dma_host_set(ide_drive_t *drive, int on)
-{
-	drive->vdma = on;
-	ide_dma_host_set(drive, on);
-}
-
 static const struct ide_port_ops cs5520_port_ops = {
 	.set_pio_mode		= cs5520_set_pio_mode,
 	.set_dma_mode		= cs5520_set_dma_mode,
 };
 
-static const struct ide_dma_ops cs5520_dma_ops = {
-	.dma_host_set		= cs5520_dma_host_set,
-	.dma_setup		= ide_dma_setup,
-	.dma_exec_cmd		= ide_dma_exec_cmd,
-	.dma_start		= ide_dma_start,
-	.dma_end		= __ide_dma_end,
-	.dma_test_irq		= ide_dma_test_irq,
-	.dma_lost_irq		= ide_dma_lost_irq,
-	.dma_timeout		= ide_dma_timeout,
-};
-
-/* FIXME: VDMA is disabled because it caused system hangs */
 #define DECLARE_CS_DEV(name_str)				\
 	{							\
 		.name		= name_str,			\
 		.port_ops	= &cs5520_port_ops,		\
-		.dma_ops	= &cs5520_dma_ops,		\
 		.host_flags	= IDE_HFLAG_ISA_PORTS |		\
 				  IDE_HFLAG_CS5520 |		\
-				  IDE_HFLAG_NO_ATAPI_DMA |	\
 				  IDE_HFLAG_ABUSE_SET_DMA_MODE, \
 		.pio_mask	= ATA_PIO4,			\
 	}

Index: b/include/linux/ide.h
===================================================================
@@ -334,7 +334,6 @@ typedef struct ide_drive_s {
 	unsigned nodma		: 1;	/* disallow DMA */
 	unsigned remap_0_to_1	: 1;	/* 0=noremap, 1=remap 0->1 (for EZDrive) */
 	unsigned blocked        : 1;	/* 1=powermanagment told us not to do anything, so sleep nicely */
-	unsigned vdma		: 1;	/* 1=doing PIO over DMA 0=doing normal DMA */
 	unsigned scsi		: 1;	/* 0=default, 1=ide-scsi emulation */
 	unsigned sleeping	: 1;	/* 1=sleeping & sleep field valid */
 	unsigned post_reset	: 1;

@@ -1083,8 +1082,6 @@ enum {
 	IDE_HFLAG_NO_IO_32BIT		= (1 << 30),
 	/* never unmask IRQs */
 	IDE_HFLAG_NO_UNMASK_IRQS	= (1 << 31),
-	/* host uses VDMA (disabled for now) */
-	IDE_HFLAG_VDMA			= 0,
 };
 
 #ifdef CONFIG_BLK_DEV_OFFBOARD