Skip to contentSkip to conversation

support for RME HDSPe RayDAT

DISCUSSION Matthijs ten Berge 2 participants 4 messages Jun 25, 2008 – Jun 26, 2008

lore
Share & tools
lore
#0 lore raw

Hello all,

<intro:>
As you might already know, RME has released a successor for the HDSP 9652, the HDSPe RayDAT
(http://www.rme-audio.de/en_products_hdspe_raydat.php). It is based on the 9652's design, with some new/changed features (e.g. more channels and lower latencies), but the most important hardware change is that it is now a PCI-express card.

I'm currently in the process of choosing which audio interface to buy, the 'old' HDSP 9652 or the new RayDAT (I haven't found any other card with 3 or more ADAT in/outs in the same price range or below, but suggestions are welcome).
Of course I can stay on the safe side and opt for the HDSP 9652, which has stable and complete driver support (right, eh?).
But on the other hand the RayDAT has better features and future, but without the guarantee that it is or will be supported it can only serve as a very costly paper weight (and not even a good one I suppose).

I wrote an e-mail to RME, but a bit too early, the card was not released at that moment. See below for their reply.

<question:>
Are there any plans to add support for the RME RayDAT to the HDSP driver/tools? Or perhaps somebody is already working on it right now? It is not mentioned in the Wiki matrix atm.
I wish I could just do it myself, but (concerning kernel programming) I never did more than a 'hello world' kernel module, so I don't think this would be a good idea... (I do have coding experience, but not in-kernel).

Quoted 1 line

From the mailings on this list I can see that it can sometimes take

quite a while to get a driver fully debugged, how are the experiences with RME cards?

I am aware that my e-mail might appear to be a crude 'I want to order a pizza asap, at what time will the delivery boy arrive?'-like question. Please see it more like a generic inquiry on the status and likelyness of things.

Thanks and cheers,

Matthijs ten Berge

---
Original message, dated 15/04/2008 (answer from RME):
---

Hello,

Quoted 4 lines

The RayDAT would be my preferred choice, because of the PCI-express interface, but is it supported by any of the ALSA drivers? I have seen that the HDSP9652 is supported by the hdsp alsa driver rather well, but how about the RayDAT?

The RayDAT is not yet released, and I'm afraid I can't say much about the current status of ALSA development (if any).

Quoted 3 lines

In case the RayDAT is not supported, are you then willing to provide information about the technical differences between the two cards, so the alsa hdsp driver can be updated/extended?

This will certainly be the case as soon as the card is released.

Regards,
Daniel Fuchs
RME

#1 lore raw

Matthijs,

Quoted 3 lines

<question:>
Are there any plans to add support for the RME RayDAT to the HDSP driver/tools? Or perhaps somebody is already working on it right now?

Yes, and no, since it is not released yet and there is only a very limited numbers of prototypes.

Adopting the drivers to support the RayDAT shouldn't take long.

Flo

Signature · 2 lines
Machines can do the work, so people have time to think.
public key 6C002249          x-hkp://wwwkeys.eu.pgp.net
#2 lore raw
Quoted 2 lines · Florian Faber

Yes, and no, since it is not released yet and there is only a very limited numbers of prototypes.

Ok, not being available yet explains a lot. Begin May, the card was already listed as 'available' at Thomann, then halfway May they mentioned 'delivery date 23rd of May', which made me conclude it is available already. But today their delivery date is listed as the 8th of July, so we'll have to wait a little longer...

I assume they didn't release the programmers documentation yet?

Quoted 4 lines

Adopting the drivers to support the RayDAT shouldn't take long.

Flo

That's good to hear. (un)fortunately it renders most of my original post superfluous ;-). Thanks for your quick reply.

Matthijs

#3 lore raw

Matthijs,

Quoted 5 lines

Ok, not being available yet explains a lot. Begin May, the card was already listed as 'available' at Thomann, then halfway May they mentioned 'delivery date 23rd of May', which made me conclude it is available already. But today their delivery date is listed as the 8th of July, so we'll have to wait a little longer...

The ADI8QS arrived one year late, so that's nothing. I'd rather have a 100% stable device than the usual rubbish.

Quoted 1 line

I assume they didn't release the programmers documentation yet?

No, it will be available with the card. But pretty soon afterwards you can expect driver support, if it is not a completely different design (which was none of the cards so far, just small differences, since they are all based on their pretty stable FPGA design).

Flo

Signature · 2 lines
Machines can do the work, so people have time to think.
public key 6C002249          x-hkp://wwwkeys.eu.pgp.net