Skip to contentSkip to conversation

2.6.26: thinkpad x60 is cooled passively

DISCUSSION Pavel Machek 5 participants 8 messages Aug 13, 2008 – Sep 8, 2008

lore
Share & tools
lore
#0 lore raw

Hi!

While verifying that -rc2 regression is gone, I noticed alarming stuff:

1) thinkpad x60 relies on passive cooling. You have nice 1.8GHz cpu, which goes away as soon as you load it.

2) after some time it decides that 100% cpu in 1.0GHz is fine for you, and it takes quite long to recover.
Pavel

Signature · 2 lines
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
#1 lore raw
Quoted 8 lines · Pavel Machek

While verifying that -rc2 regression is gone, I noticed alarming stuff:

1) thinkpad x60 relies on passive cooling. You have nice 1.8GHz cpu, which goes away as soon as you load it.

2) after some time it decides that 100% cpu in 1.0GHz is fine for you, and it takes quite long to recover.

There is no fan in the X60? I didn't think that was the case. I do know the fans have a tendency to go bad within 12-18 months, and so the CPU heat sink and fan unit needs to be replaced perdiocially. What does /proc/acpi/ibm/fan report?

Or are you saying that the fan isn't keeping keeping up with the heat output of the CPU? Are you sure this isn't due to a hardware problem? As mentioned previously on this list, Lenovo has had a relatively bad track record with fan failures and with incompetent installation of the heat sink with bad applications of the thermal compound; it's the one failings of an otherwise very nice laptop design.

- Ted

#2 lore raw
Quoted 7 lines · Theodore Tso
Quoted 6 lines · Pavel Machek

While verifying that -rc2 regression is gone, I noticed alarming stuff:

1) thinkpad x60 relies on passive cooling. You have nice 1.8GHz cpu, which goes away as soon as you load it.

Quoted 7 lines
Quoted 2 lines

2) after some time it decides that 100% cpu in 1.0GHz is fine for you, and it takes quite long to recover.

There is no fan in the X60? I didn't think that was the case. I do know the fans have a tendency to go bad within 12-18 months, and so the CPU heat sink and fan unit needs to be replaced perdiocially. What does /proc/acpi/ibm/fan report?

3700 on level 7, more (like 4700) on disengaged, but still not enough to keep it from going to 1GHz.

Quoted 3 lines

Or are you saying that the fan isn't keeping keeping up with the heat output of the CPU? Are you sure this isn't due to a hardware problem?

Yes, I'm trying to say that the fan isn't keeping keeping up with the heat output of the CPU.

Quoted 4 lines

As mentioned previously on this list, Lenovo has had a relatively bad track record with fan failures and with incompetent installation of the heat sink with bad applications of the thermal compound; it's the one failings of an otherwise very nice laptop design.

Hmm, ok, maybe. It is true that nearby X60p behaved slightly differently.
Pavel

Signature · 2 lines
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
#3 lore raw
In reply to Theodore Tso
Quoted 11 lines · Theodore Tso
Quoted 8 lines · Pavel Machek

While verifying that -rc2 regression is gone, I noticed alarming stuff:

1) thinkpad x60 relies on passive cooling. You have nice 1.8GHz cpu, which goes away as soon as you load it.

2) after some time it decides that 100% cpu in 1.0GHz is fine for you, and it takes quite long to recover.

There is no fan in the X60? I didn't think that was the case. I do

It has a fan, yes.

Quoted 3 lines

know the fans have a tendency to go bad within 12-18 months, and so the CPU heat sink and fan unit needs to be replaced perdiocially. What does /proc/acpi/ibm/fan report?

ThinkPad fans have a overdesign range of about 2x, they almost never stop because they're too old. Clogged in dirt, on the other hand... a clogged fan often spins FASTER and cools less.

Want to see how much your fan has as far as a safety margin goes? use thinkpad-acpi to measure RPMs in level 7 and also when you switch PWM off (i.e. set it to 100% duty cycle). Mine gets faster by 1500RPM or so that reflects the extra torque the EC can apply to get the fan to run at the speed it wants it to.

But the thermal sink interface to the CPU and GPU are sometimes crap [when compared with the quality of the rest of the machine]. Open it, remove the crap, and replace it with a very high quality compound. Dependin on ThinkPad model, you also need to repair thermal sink design defects to make it fit properly (read: press really tightly) on all chips.

Quoted 4 lines

As mentioned previously on this list, Lenovo has had a relatively bad track record with fan failures and with incompetent installation of the heat sink with bad applications of the thermal compound; it's the one failings of an otherwise very nice laptop design.

Indeed.

Signature · 4 lines
  "One disk to rule them all, One disk to find them. One disk to bring
  them all and in the darkness grind them. In the Land of Redmond
  where the shadows lie." -- The Silicon Valley Tarot
  Henrique Holschuh
#4 lore raw
Quoted 8 lines · Henrique de Moraes Holschuh
Quoted 3 lines

know the fans have a tendency to go bad within 12-18 months, and so the CPU heat sink and fan unit needs to be replaced perdiocially. What does /proc/acpi/ibm/fan report?

ThinkPad fans have a overdesign range of about 2x, they almost never stop because they're too old. Clogged in dirt, on the other hand... a clogged fan often spins FASTER and cools less.

Quoted 5 lines

Want to see how much your fan has as far as a safety margin goes? use thinkpad-acpi to measure RPMs in level 7 and also when you switch PWM off (i.e. set it to 100% duty cycle). Mine gets faster by 1500RPM or so that reflects the extra torque the EC can apply to get the fan to run at the speed it wants it to.

Hmm, maybe I've just had bad luck, or I live in a very dusty environment (four cats, including two longhairs in perma-shed mode, will do that to any house), but I've had at least 3 fan failures in the past 5-6 years where the fan stopped entirely, and had to be replaced. When I took it out, it was quite dirty, but the way it spun why I tried moving the fan blades with my finger, it felt just like the failure modes I've had with standard power supply fans that have gone bad due to old age.

- Ted

#5 lore raw
Quoted 15 lines · Theodore Tso
Quoted 8 lines · Henrique de Moraes Holschuh
Quoted 3 lines

know the fans have a tendency to go bad within 12-18 months, and so the CPU heat sink and fan unit needs to be replaced perdiocially. What does /proc/acpi/ibm/fan report?

ThinkPad fans have a overdesign range of about 2x, they almost never stop because they're too old. Clogged in dirt, on the other hand... a clogged fan often spins FASTER and cools less.

Quoted 5 lines

Want to see how much your fan has as far as a safety margin goes? use thinkpad-acpi to measure RPMs in level 7 and also when you switch PWM off (i.e. set it to 100% duty cycle). Mine gets faster by 1500RPM or so that reflects the extra torque the EC can apply to get the fan to run at the speed it wants it to.

Quoted 8 lines

Hmm, maybe I've just had bad luck, or I live in a very dusty environment (four cats, including two longhairs in perma-shed mode, will do that to any house), but I've had at least 3 fan failures in the past 5-6 years where the fan stopped entirely, and had to be replaced. When I took it out, it was quite dirty, but the way it spun why I tried moving the fan blades with my finger, it felt just like the failure modes I've had with standard power supply fans that have gone bad due to old age.

Okay, seems like vojtech fixed my notebook with a bit of compressed air... a lot of dust came out, and machine works okay now.
Pavel

Signature · 2 lines
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
#6 lore raw
Quoted 2 lines · Pavel Machek

Okay, seems like vojtech fixed my notebook with a bit of compressed air... a lot of dust came out, and machine works okay now.

Amazing what that does.

My wife's Asus R1F was giving occational "throtled CPU due to overtemperature" and I took the cpu fan out and removed the dust from the heatsink using a q-tip, and the cpu temperature dropped 16C and the fan is much quieter now. I will have to remember to do that more often.

Signature · 1 line
Len Sorensen
#7 lore raw
In reply to Henrique de Moraes Holschuh
Quoted 10 lines · Henrique de Moraes Holschuh

ThinkPad fans have a overdesign range of about 2x, they almost never stop because they're too old. Clogged in dirt, on the other hand... a clogged fan often spins FASTER and cools less.

Want to see how much your fan has as far as a safety margin goes? use thinkpad-acpi to measure RPMs in level 7 and also when you switch PWM off (i.e. set it to 100% duty cycle). Mine gets faster by 1500RPM or so that reflects the extra torque the EC can apply to get the fan to run at the speed it wants it to.

Quoted 5 lines

But the thermal sink interface to the CPU and GPU are sometimes crap [when compared with the quality of the rest of the machine]. Open it, remove the crap, and replace it with a very high quality compound. Dependin on ThinkPad model, you also need to repair thermal sink design defects to make it fit properly (read: press really tightly) on all chips.

Yes, this seems like a widespread and chronic problem with these little Thinkpads. I've had both an X31 and X60 go bad this way, and a friend has had his X60 fail twice. A pity given how nice the rest of the machine is.

J