Leadtek Winfast Dongle H (hybrid)
Hello everyone, I was asked by my friend to help him with his DVB USB card (based on STK7700PH):
Bus 008 Device 005: ID 0413:60f6 Leadtek Research, Inc.
...and I found, that card isn't yet supported, but there is all code for it now.
So I add new device into list:
dib0700_devices.c +0 -0
@@ -1117,7 +1117,8 @@ { USB_DEVICE(USB_VID_TERRATEC,
USB_PID_TERRATEC_CINERGY_HT_EXPRESS) },
{ USB_DEVICE(USB_VID_TERRATEC, USB_PID_TERRATEC_CINERGY_T_XXS) },
{ USB_DEVICE(USB_VID_LEADTEK,USB_PID_WINFAST_DTV_DONGLE_STK7700P_2) },
- { USB_DEVICE(USB_VID_HAUPPAUGE,USB_PID_HAUPPAUGE_NOVA_TD_STICK_52009) },
+/* 35 */{ USB_DEVICE(USB_VID_HAUPPAUGE,USB_PID_HAUPPAUGE_NOVA_TD_STICK_52009) },
+ { USB_DEVICE(USB_VID_LEADTEK, USB_PID_WINFAST_DTV_DONGLE_HYBRID) },
{ 0 } /* Terminating entry */
};
MODULE_DEVICE_TABLE(usb, dib0700_usb_id_table);
@@ -1403,7 +1404,7 @@
},
},
- .num_device_descs = 3,
+ .num_device_descs = 4,
.devices = {
{ "Terratec Cinergy HT USB XE",
{ &dib0700_usb_id_table[27], NULL },
@@ -1417,6 +1418,10 @@
{ &dib0700_usb_id_table[32], NULL }, { NULL },
},
+ { "Leadtek Winfast Dongle Hybrid",
+ { &dib0700_usb_id_table[36], NULL },
+ { NULL },
+ },
},
.rc_interval = DEFAULT_RC_INTERVAL,
.rc_key_map = dib0700_rc_keys,
dvb-usb-ids.h +1 -0
@@ -189,6 +189,7 @@#define USB_PID_WINFAST_DTV_DONGLE_WARM 0x6026#define USB_PID_WINFAST_DTV_DONGLE_STK7700P 0x6f00#define USB_PID_WINFAST_DTV_DONGLE_STK7700P_2 0x6f01 +#define USB_PID_WINFAST_DTV_DONGLE_HYBRID 0x60f6#define USB_PID_GENPIX_8PSK_REV_1_COLD 0x0200#define USB_PID_GENPIX_8PSK_REV_1_WARM 0x0201#define USB_PID_GENPIX_8PSK_REV_2 0x0202
After patching, card works as DVB-T reciever (confirmed by someone other with this card and with DVB-T signal). This card can receive analog TV too, it has cx25843 (cx25840 compatible) chip for it, but there is not any connection between this subsystems.
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb