smc91x support for edosk7760 (smc91c96 ethernet chip)

@@ -429,6 +429,36 @@
 
 #include <asm/unit/smc91111.h>
 
+
+
+#elif defined(CONFIG_SH_EDOSK7760) //SPES
+
+/* SMC91C96 registers are 4 byte aligned rather than the
+ * usual 2 byte!
+ */
+#define SMC_IO_SHIFT 1 //SPES
+
+#define SMC_CAN_USE_8BIT	1
+#define SMC_CAN_USE_16BIT	1
+#define SMC_CAN_USE_32BIT	1
+#define SMC_NOWAIT		1
+
+#define SMC_inb(a, r)		readb((a) + (r))
+#define SMC_inw(a, r)		readw((a) + (r))
+#define SMC_inl(a, r)		readl((a) + (r))
+#define SMC_outb(v, a, r)	writeb(v, (a) + (r))
+#define SMC_outw(v, a, r)	writew(v, (a) + (r))
+#define SMC_outl(v, a, r)	writel(v, (a) + (r))
+#define SMC_insw(a, r, p, l)	readsw((a) + (r), p, l)
+#define SMC_outsw(a, r, p, l)	writesw((a) + (r), p, l)
+#define SMC_insl(a, r, p, l)	readsl((a) + (r), p, l)
+#define SMC_outsl(a, r, p, l)	writesl((a) + (r), p, l)
+
+#define RPC_LSA_DEFAULT		RPC_LED_100_10
+#define RPC_LSB_DEFAULT		RPC_LED_TX_RX
+
+#define SMC_DYNAMIC_BUS_CONFIG
+
 #else
 
 /*

@@ -702,7 +732,6 @@
 */
 #define BANK_SELECT		(14 << SMC_IO_SHIFT)
 
-
 // Transmit Control Register
 /* BANK 0  */
 #define TCR_REG(lp) 	SMC_REG(lp, 0x0000, 0)

@@ -1252,9 +1281,9 @@
 
 #define SMC_PUT_PKT_HDR(lp, status, length)				\
 	do {								\
-		if (SMC_32BIT(lp))					\
+		if (SMC_32BIT(lp)){					\
 			SMC_outl((status) | (length)<<16, ioaddr,	\
-				 DATA_REG(lp));			\
+				 DATA_REG(lp));	}		\
 		else {							\
 			SMC_outw(status, ioaddr, DATA_REG(lp));	\
 			SMC_outw(length, ioaddr, DATA_REG(lp));	\

@@ -1334,4 +1363,10 @@
 			SMC_insb(ioaddr, DATA_REG(lp), p, l);		\
 	} while (0)
 
+
+
+
+
+
+
 #endif  /* _SMC91X_H_ */