atl2: add atl2 driver
Subsystems (3)
PATCH 1/1 atl2: add atl2 driver
From: Chris Snook <[email protected]>
Driver for Atheros L2 10/100 network device. Includes necessary changes for Kconfig, Makefile, and pci_ids.h.
Sighed-off-by Chris Snook <[email protected]>
Signed-off-by Jay Cliburn <[email protected]>
---
If this file is too large for vger, the full patch may be obtained from ftp://ftp.hogchain.net/pub/linux/attansic/atlx/0001-atl2-add-atl2-driver.patch
drivers/net/Kconfig | 11 + drivers/net/Makefile | 1 + drivers/net/atlx/Makefile | 2 + drivers/net/atlx/atl2.c | 3127 +++++++++++++++++++++++++++++++++++++++++++++ drivers/net/atlx/atl2.h | 530 ++++++++ include/linux/pci_ids.h | 1 + 6 files changed, 3672 insertions(+), 0 deletions(-)
drivers/net/Kconfig +11 -0
@@ -1840,6 +1840,17 @@ config NE_H8300 Say Y here if you want to use the NE2000 compatible controller on the Renesas H8/300 processor. +config ATL2 + tristate "Atheros L2 Fast Ethernet support" + depends on PCI + select CRC32 + select MII + help + This driver supports the Atheros L2 fast ethernet adapter. + + To compile this driver as a module, choose M here. The module + will be called atl2. + source "drivers/net/fs_enet/Kconfig" endif # NET_ETHERNET
drivers/net/Makefile +1 -0
@@ -15,6 +15,7 @@ obj-$(CONFIG_EHEA) += ehea/ obj-$(CONFIG_CAN) += can/ obj-$(CONFIG_BONDING) += bonding/ obj-$(CONFIG_ATL1) += atlx/ +obj-$(CONFIG_ATL2) += atlx/ obj-$(CONFIG_ATL1E) += atl1e/ obj-$(CONFIG_GIANFAR) += gianfar_driver.o obj-$(CONFIG_TEHUTI) += tehuti.o
drivers/net/atlx/Makefile +2 -0
@@ -1 +1,3 @@ obj-$(CONFIG_ATL1) += atl1.o +obj-$(CONFIG_ATL2) += atl2.o +
drivers/net/atlx/atl2.c new file +3127 -0
2,973 lines not on this page · raw message
drivers/net/atlx/atl2.h new file +530 -0
530 lines not on this page · raw message
The rest of this diff is not shown. View the raw message.
Signature · 1 line
1.5.5.1
Part of the diff is not shown here. View the raw message.