Skip to contentSkip to conversation

forcedeth: add pci_enable_device() to nv_resume()

PATCH Applied [email protected] 1 participant 1 message Sep 22, 2008

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 9/21 forcedeth: add pci_enable_device() to nv_resume()

From: Simon Arlott <[email protected]>

My NIC stops working after resuming from standby, it's not receiving any interrupts.

Commit 25d90810ff49d2a63475776f24c74c6bb49b045f ([netdrvr] forcedeth:
reorder suspend/resume code) introduces pci_disable_device to nv_suspend, but there's no corresponding pci_enable_device in nv_resume - so I added one (copied from e1000). This results in interrupts being re-enabled after suspend.

However, the NIC (10de:0373) still doesn't work after resume.

Cc Tobias Diedrich <[email protected]>
Cc Jeff Garzik <[email protected]>
Cc Ayaz Abdulla <[email protected]>

---

 drivers/net/forcedeth.c |    7 +++++++
 1 file changed, 7 insertions(+)
drivers/net/forcedeth.c renamed from drivers/net/forcedeth.c~forcedeth-add-pci_enable_device-to-nv_resume +7 -0
diff -puN drivers/net/forcedeth.c~forcedeth-add-pci_enable_device-to-nv_resume drivers/net/forcedeth.c
@@ -5968,6 +5968,13 @@ static int nv_resume(struct pci_dev *pde
 
 	pci_set_power_state(pdev, PCI_D0);
 	pci_restore_state(pdev);
+	rc = pci_enable_device(pdev);
+	if (rc) {
+		printk(KERN_ERR "forcedeth: Cannot enable PCI device from suspend\n");
+		return rc;
+	}
+	pci_set_master(pdev);
+
 	/* ack any pending wake events, disable PME */
 	pci_enable_wake(pdev, PCI_D0, 0);
 

_