Skip to contentSkip to conversation

spi: atmel_spi update chipselect handling

PATCH New David Brownell 1 participant 1 message Nov 22, 2008

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 spi: atmel_spi update chipselect handling

From: Haavard Skinnemoen <[email protected]>

This solves several issues:
* It fixes the wrong idle clock polarity issue in a cleaner and less expensive way.
* It handles the AT32AP7000 errata "SPI Chip Select 0 BITS field overrides other Chip Selects". Other chips, e.g. AT91SAM9261, have similar issues.

Currently, the AT91RM9200 code path is left alone. But it might be interesting to try the same technique on RM9200 using a different CSR register.

[ [email protected]: restore debug message for activation ]
---
 drivers/spi/atmel_spi.c |   91 +++++++++++++++++++++++++++++++++-------------
 1 file changed, 66 insertions(+), 25 deletions(-)
drivers/spi/atmel_spi.c +66 -25
@@ -51,6 +51,12 @@ struct atmel_spi {
 	dma_addr_t		buffer_dma;
 };
 
+/* Controller-specific per-slave state */
+struct atmel_spi_device {
+	unsigned int		npcs_pin;
+	u32			csr;
+};
+
 #define BUFFER_SIZE		PAGE_SIZE
 #define INVALID_DMA_ADDRESS	0xffffffff
 
@@ -89,39 +95,58 @@ static bool atmel_spi_is_v2(void)
  * Master on Chip Select 0.")  No workaround exists for that ... so for
  * nCS0 on that chip, we (a) don't use the GPIO, (b) can't support CS_HIGH,
  * and (c) will trigger that first erratum in some cases.
+ *
+ * TODO: Test if the atmel_spi_is_v2() branch below works on
+ * AT91RM9200 if we use some other register than CSR0. However, don't
+ * do this unconditionally since AP7000 has an errata where the BITS
+ * field in CSR0 overrides all other CSRs.
  */
 
 static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
 {
-	unsigned gpio = (unsigned) spi->controller_data;
+	struct atmel_spi_device *asd = spi->controller_state;
 	unsigned active = spi->mode & SPI_CS_HIGH;
 	u32 mr;
-	int i;
-	u32 csr;
-	u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0;
 
-	/* Make sure clock polarity is correct */
-	for (i = 0; i < spi->master->num_chipselect; i++) {
-		csr = spi_readl(as, CSR0 + 4 * i);
-		if ((csr ^ cpol) & SPI_BIT(CPOL))
-			spi_writel(as, CSR0 + 4 * i, csr ^ SPI_BIT(CPOL));
-	}
+	if (atmel_spi_is_v2()) {
+		/*
+		 * Always use CSR0. This ensures that the clock
+		 * switches to the correct idle polarity before we
+		 * toggle the CS.
+		 */
+		spi_writel(as, CSR0, asd->csr);
+		spi_writel(as, MR, SPI_BF(PCS, 0x0e) | SPI_BIT(MODFDIS)
+				| SPI_BIT(MSTR));
+		mr = spi_readl(as, MR);
+		gpio_set_value(asd->npcs_pin, active);
+	} else {
+		u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0;
+		int i;
+		u32 csr;
 
-	mr = spi_readl(as, MR);
-	mr = SPI_BFINS(PCS, ~(1 << spi->chip_select), mr);
+		/* Make sure clock polarity is correct */
+		for (i = 0; i < spi->master->num_chipselect; i++) {
+			csr = spi_readl(as, CSR0 + 4 * i);
+			if ((csr ^ cpol) & SPI_BIT(CPOL))
+				spi_writel(as, CSR0 + 4 * i,
+						csr ^ SPI_BIT(CPOL));
+		}
+
+		mr = spi_readl(as, MR);
+		mr = SPI_BFINS(PCS, ~(1 << spi->chip_select), mr);
+		if (spi->chip_select != 0)
+			gpio_set_value(asd->npcs_pin, active);
+		spi_writel(as, MR, mr);
+	}
 
 	dev_dbg(&spi->dev, "activate %u%s, mr %08x\n",
-			gpio, active ? " (high)" : "",
+			asd->npcs_pin, active ? " (high)" : "",
 			mr);
-
-	if (atmel_spi_is_v2() || spi->chip_select != 0)
-		gpio_set_value(gpio, active);
-	spi_writel(as, MR, mr);
 }
 
 static void cs_deactivate(struct atmel_spi *as, struct spi_device *spi)
 {
-	unsigned gpio = (unsigned) spi->controller_data;
+	struct atmel_spi_device *asd = spi->controller_state;
 	unsigned active = spi->mode & SPI_CS_HIGH;
 	u32 mr;
 
@@ -135,11 +160,11 @@ static void cs_deactivate(struct atmel_s
 	}
 
 	dev_dbg(&spi->dev, "DEactivate %u%s, mr %08x\n",
-			gpio, active ? " (low)" : "",
+			asd->npcs_pin, active ? " (low)" : "",
 			mr);
 
 	if (atmel_spi_is_v2() || spi->chip_select != 0)
-		gpio_set_value(gpio, !active);
+		gpio_set_value(asd->npcs_pin, !active);
 }
 
 static inline int atmel_spi_xfer_is_last(struct spi_message *msg,
@@ -511,6 +536,7 @@ atmel_spi_interrupt(int irq, void *dev_i
 static int atmel_spi_setup(struct spi_device *spi)
 {
 	struct atmel_spi	*as;
+	struct atmel_spi_device	*asd;
 	u32			scbr, csr;
 	unsigned int		bits = spi->bits_per_word;
 	unsigned long		bus_hz;
@@ -595,11 +621,20 @@ static int atmel_spi_setup(struct spi_de
 
 	/* chipselect must have been muxed as GPIO (e.g. in board setup) */
 	npcs_pin = (unsigned int)spi->controller_data;
-	if (!spi->controller_state) {
+	asd = spi->controller_state;
+	if (!asd) {
+		asd = kzalloc(sizeof(struct atmel_spi_device), GFP_KERNEL);
+		if (!asd)
+			return -ENOMEM;
+
 		ret = gpio_request(npcs_pin, spi->dev.bus_id);
-		if (ret)
+		if (ret) {
+			kfree(asd);
 			return ret;
-		spi->controller_state = (void *)npcs_pin;
+		}
+
+		asd->npcs_pin = npcs_pin;
+		spi->controller_state = asd;
 		gpio_direction_output(npcs_pin, !(spi->mode & SPI_CS_HIGH));
 	} else {
 		unsigned long		flags;
@@ -611,11 +646,14 @@ static int atmel_spi_setup(struct spi_de
 		spin_unlock_irqrestore(&as->lock, flags);
 	}
 
+	asd->csr = csr;
+
 	dev_dbg(&spi->dev,
 		"setup: %lu Hz bpw %u mode 0x%x -> csr%d %08x\n",
 		bus_hz / scbr, bits, spi->mode, spi->chip_select, csr);
 
-	spi_writel(as, CSR0 + 4 * spi->chip_select, csr);
+	if (!atmel_spi_is_v2())
+		spi_writel(as, CSR0 + 4 * spi->chip_select, csr);
 
 	return 0;
 }
@@ -690,10 +728,11 @@ static int atmel_spi_transfer(struct spi
 static void atmel_spi_cleanup(struct spi_device *spi)
 {
 	struct atmel_spi	*as = spi_master_get_devdata(spi->master);
+	struct atmel_spi_device	*asd = spi->controller_state;
 	unsigned		gpio = (unsigned) spi->controller_data;
 	unsigned long		flags;
 
-	if (!spi->controller_state)
+	if (!asd)
 		return;
 
 	spin_lock_irqsave(&as->lock, flags);
@@ -703,7 +742,9 @@ static void atmel_spi_cleanup(struct spi
 	}
 	spin_unlock_irqrestore(&as->lock, flags);
 
+	spi->controller_state = NULL;
 	gpio_free(gpio);
+	kfree(asd);
 }
 
 /*-------------------------------------------------------------------------*/

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/