smc91x: struct net_device_ops
Subsystems (2)
PATCH 1/1 smc91x: struct net_device_ops
From: Magnus Damm <[email protected]>
Convert the smc91x driver to use struct net_device_ops.
Signed-off-by Magnus Damm <[email protected]>
---
drivers/net/smc91x.c | 22 ++++++++++++++-------- 1 file changed, 14 insertions(+), 8 deletions(-)
drivers/net/smc91x.c +14 -8
@@ -1768,6 +1768,19 @@ static const struct ethtool_ops smc_etht .set_eeprom = smc_ethtool_seteeprom, }; +static const struct net_device_ops smc_netdev_ops = { + .ndo_open = smc_open, + .ndo_stop = smc_close, + .ndo_start_xmit = smc_hard_start_xmit, + .ndo_tx_timeout = smc_timeout, + .ndo_set_multicast_list = smc_set_multicast_list, + .ndo_validate_addr = eth_validate_addr, + .ndo_set_mac_address = eth_mac_addr, +#ifdef CONFIG_NET_POLL_CONTROLLER + .ndo_poll_controller = smc_poll_controller, +#endif +}; +/* * smc_findirq *
@@ -1977,16 +1990,9 @@ static int __devinit smc_probe(struct ne/* Fill in the fields of the device structure with ethernet values. */ ether_setup (dev); - dev->open = smc_open; - dev->stop = smc_close; - dev->hard_start_xmit = smc_hard_start_xmit; - dev->tx_timeout = smc_timeout; dev->watchdog_timeo =msecs_to_jiffies (watchdog); - dev->set_multicast_list = smc_set_multicast_list; + dev->netdev_ops = &smc_netdev_ops; dev->ethtool_ops = &smc_ethtool_ops; -#ifdef CONFIG_NET_POLL_CONTROLLER - dev->poll_controller = smc_poll_controller; -#endif tasklet_init (&lp->tx_task, smc_hardware_send_pkt, (unsigned long )dev);INIT_WORK (&lp->phy_configure, smc_phy_configure);
From: Magnus Damm <[email protected]>
Date: Mon, 26 Jan 2009 15:55:18 +0900
Quoted 3 lines
Convert the smc91x driver to use struct
net_device_ops.Signed-off-by Magnus Damm <[email protected]>
Applied, thanks Magnus.